Your Selected Vehicle
Parts for your 2012 Suzuki Splash-Batteries
LED Autolamps 355 Series Multi Volt Black Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Twin Blister Pack - 355BARWM-2
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Blister Pack - 235ASEQ-2
LED Autolamps 12/24V 280 Mini Jumbo Stop/Tail/Indicator Lamp Blister Pack - 280ARRM
LED Autolamps Twin function side indicator with amber side marker - 97CAIMCSB
Explore 4WD & Adventure
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Bulk Packaging - 235ASEQB
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reflector Light 28cm Cable Blister Pack - 275MAR
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps 12V Stop/Tail/Ind/Rev LED Light Kit 450mm Loom DT04 Connector - SO282ARWM2LR450
LED Autolamps 12/24V Stop/Tail/Indicator/Reflector With Licence Plate Lamp - 99ARLM
LED Autolamps 12V Front Indicator/Marker Lamp 80mm Round Blister Pack - 80AW
LED Autolamps 10/30V LED Side Direction Indicator Light With 3m Tinned Cable - 58AM3
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp With Inbuild Reflectors - 283ARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Lamp With Reflex Reflector Blister Pack 1 pce - 150ARM
LED Autolamps Multi Volt Reverse Lamp With 35 SMDS Blister Pack With Black Base - 135WM
LED Autolamps 12V Stop/Tail/Indicator/Reverse With Reflectors And 500mm LP Cable - SO283ARWM2LR12
LED Autolamps 12V LED Stop/Tail/Indicator Assembly Light With Black Bracket - 80BAR
LED Autolamps 9/30V LED Red Amber Side Marker Light Clear Lens 30cm Wire - 35ARMB
LED Autolamps Multi Volt Stop/Tail/Indicator Assembly 72 LEDs With Black Bracket - 200BARM
2012 Suzuki Splash batteries
Technical sources confirm the 2012 Suzuki Splash is fitted with a conventional 12‑volt lead‑acid starter battery. This is detailed in the 2012 Suzuki Splash Owner’s Manual and Electrical (Starting/Charging) sections of the service manual, and is supported by application data from major battery catalogues used in Australia and New Zealand (e.g., Century Yuasa and Exide) as well as the closely related Opel/Vauxhall Agila B documentation. So, yes—batteries are absolutely relevant to the 2012 Splash.
In a 2012 Splash, the battery’s job is pretty simple but seriously important. It delivers the grunt to crank the engine, powers essentials like the ECU, fuel pump, coils and injectors during start‑up, and stabilises vehicle voltage so electronics behave predictably under the bonnet and in the cabin. With lots of short trips and stop–start city driving, Splash batteries can work harder than many expect, especially in cooler winters or hot Aussie and Kiwi summers.
As part of servicing, it pays to keep an eye on battery health. Most owners will see 3–5 years from a quality unit, depending on climate and driving patterns. Annual testing under load, checking cold‑cranking amps (CCA) against spec, and a quick look at the state‑of‑charge will catch issues before they turn into a no‑start drama at the servo. Corroded terminals, a loose hold‑down, or a tired alternator can mimic a “dead” battery, so proper diagnosis matters.
- Choose a battery that matches the correct case size, terminal layout and CCA listed in reputable AU/NZ fitment guides for the 2012 Splash.
- If the car isn’t driven much, a smart maintainer keeps charge levels healthy and prevents sulphation.
- Clean and tighten terminals, use dielectric protection to slow corrosion.
- When replacing, maintain power with a memory saver if needed, confirm polarity, secure the hold‑down, and reset clocks/windows as required.
- AGM/EFB units aren’t usually necessary unless specified, a quality maintenance‑free lead‑acid battery is typical for this model.
Common signs it’s time to replace include slow cranking, dim lights at idle, repeated jump‑starts, or a battery that won’t hold charge after an overnight rest. For owners doing frequent short trips, an occasional longer run helps the alternator fully recharge the battery. A workshop test every service interval is a smart—and inexpensive—way to avoid surprises.
Popular questions
What battery type suits a 2012 Suzuki Splash in Australia or New Zealand?
Most 2012 Splash models use a conventional 12‑volt maintenance‑free lead‑acid battery with a compact case and standard post terminals. The exact size and cold‑cranking amps vary by engine and market, so matching what reputable AU/NZ battery catalogues list for the Splash (2012) is the safest bet.
How long should the battery last in a 2012 Splash?
Typically 3–5 years. City driving with lots of short trips, temperature extremes, and added accessories can shorten that. Annual battery and charging‑system checks during routine servicing help extend life and catch issues early.
Does the Splash need coding after a battery change?
Generally, no. The 2012 Splash doesn’t usually require battery “coding.” After replacement, some settings like the clock or radio presets may need a quick reset. If aftermarket electronics are fitted, follow their specific instructions.