Parts for your 2012 Nissan Tiida-Gas struts

2012 Nissan Tiida gas struts

Based on technical references, gas struts are factory-fitted on the 2012 Nissan Tiida hatchback to support the rear liftgate, while the sedan’s boot uses torsion bars and the bonnet is held up by a prop rod. Sources: Nissan Tiida/Versa C11 Series Service Manual (Body/Liftgate section: “Back Door Stay, Gas-Filled”), Nissan FAST electronic parts catalogue listings for “Stay Assy—Back Door (LH/RH)” on C11 hatch, and general repair guides (e.g., Haynes/Max Ellery) noting a bonnet prop rod on economy variants. So, gas struts are relevant for the Tiida hatch’s tailgate but not typically used on the sedan boot or the bonnet.

On the 2012 Tiida hatch, the gas struts (sometimes called lift supports or gas stays) make the tailgate easy to lift and stop it from dropping on someone’s head. Each strut is a sealed, nitrogen-charged damper that counterbalances the weight of the hatch and controls its motion, especially in windy or uneven situations. When they’re healthy, the liftgate pops up smoothly and stays put, when they’re tired, it feels heavy, lifts slowly—especially on cold mornings—or sags back down.

As part of routine servicing, it’s smart to check the gas struts a couple of times a year. A quick test: open the hatch halfway and see if it holds. If it creeps down, leaves grease on the shaft, or makes notchy movements, they’re likely due. Because both sides share the load, replacement in pairs is the go-to move for consistent lift and longevity. Most replacement sets clip straight on to the existing ball studs, so the job is usually a simple remove-and-refit.

• Always support the hatch with a prop or a helper before removing a strut.
• Pop the metal retaining clip with a small flat screwdriver and pull the socket off the ball—no need to fully remove the clip.
• Install new struts with the body (fat end) up where specified, so the internal oil keeps the seal lubricated.
• Don’t grease the shaft, just keep it clean. Wipe with a dry cloth.
• If hardware is worn, replace the ball studs as well for a snug fit.

Service life varies with climate and use, but many owners see 5–10 years. If the hatch won’t stay up, fails a safety check, or feels heavier than usual, fresh gas struts restore that easy, one-hand operation Tiida drivers expect.

Popular questions

How long do Tiida hatch gas struts usually last?
Expect roughly 5–10 years depending on heat, dust, and how often the hatch is used. Cold weather will often show weakness sooner. If one side fades, replace both for balanced lift and better durability.

Can Tiida gas struts be re-gassed or should they be replaced?
They’re sealed units. While re-gassing is sometimes advertised, it’s not typically recommended for these struts. Replacement with quality units is the reliable, cost-effective fix.

Do Tiida sedans have boot gas struts?
No. The 2012 Tiida sedan uses torsion bars for the boot lid, so there are no gas struts back there. Only the hatchback’s tailgate uses gas struts from factory.