Parts for your 2012 Honda Cr-v-Pedal pads

2012 Honda CR‑V pedal pads — what they do and how to look after them

Based on Honda’s own technical literature, pedal pads are absolutely relevant to the 2012 Honda CR‑V. The Honda Electronic Parts Catalogue for the RM‑series CR‑V lists a replaceable rubber pad on the brake pedal, and the Honda Service Manual for RM models shows the pad as a separate, serviceable item on the brake pedal assembly. Manual‑transmission variants also carry a rubber clutch pedal pad. The accelerator pedal on this model uses a moulded, textured face and isn’t a separate “pad”. The 2012 CR‑V Owner’s Manual further notes checking pedal condition and operation during routine maintenance.

On this CR‑V, the pedal pad’s job is simple but vital: give reliable, non‑slip grip underfoot so braking (and clutch operation on manuals) feels consistent in the wet, with sandy shoes, or after a long motorway run. Over time, the rubber hardens, polishes smooth, or cracks at the edges, and that’s when replacement is due.

As part of servicing, a good workshop will eyeball and feel the pad surface. If it’s shiny, slippery when damp, cracked, torn at the corners, or starting to pop off the metal pedal, it’s time for a new one. Replacement is quick and inexpensive: the old pad slips off, the pedal face is cleaned, and a genuine‑spec pad is worked on from one edge and seated fully around the lip. No adhesives are needed when the correct part is used.

Helpful tips for owners between services:

• Keep the pad clean. Wipe off mud and road grit so the texture can bite properly.
• Avoid petroleum‑based cleaners, they can dry and swell the rubber. Mild soap and water is fine.
• Check floor mats are clipped in place and don’t ride up under the pedals.
• If the pad feels slick in wet shoes, don’t wait — have it replaced.

For automatic CR‑Vs, only the brake pedal has a replaceable pad. Manual models add a clutch pad with the same inspection and replacement approach. Sticking with genuine or OE‑quality rubber ensures the correct fit and the right hardness for Aussie and Kiwi conditions.

Technical sources referenced: Honda Electronic Parts Catalogue (RM1–RM4, Brake Pedal group), Honda CR‑V 2012 Owner’s Manual (RM series), Controls/Driving section, Honda Service Manual (RM), Brake Pedal — Inspection and Component Replacement.

Does the 2012 Honda CR‑V have a replaceable brake pedal pad?

Yes. All 2012 CR‑V variants are fitted with a rubber brake pedal pad that’s designed to be replaced when worn. It’s a simple, low‑cost safety item.

Do manual 2012 CR‑Vs have a clutch pedal pad as well?

They do. Manual‑transmission models have a separate rubber pad on the clutch pedal, inspected and replaced the same way as the brake pad.

How often should the pedal pads be replaced on a 2012 CR‑V?

There’s no fixed kilometre interval. Replace whenever the surface is shiny, hard, cracked, or the pad is loose. Having them checked at each service is the smart move.