Parts for your 2011 Subaru Exiga-Pedal pads

2011 Subaru Exiga pedal pads: what they do and when to replace them

Yes, pedal pads are used on the 2011 Subaru Exiga. Subaru’s own technical references list them: the Subaru FAST electronic parts catalogue for the YA-series Exiga specifies a rubber brake pedal pad (commonly referenced as 36012AE000) and, on manual models, a rubber clutch pedal pad (often listed as 36023AE010). The accelerator on this model is a plastic pedal assembly without a removable rubber pad. Subaru service manuals also call out inspection of non‑slip pedal surfaces during routine servicing.

On this Exiga, the brake (and clutch, if manual) pedal pads are simple rubber covers that deliver grip, comfort and consistent pedal feel. They help stop boots slipping in the wet, reduce vibration, and keep the pedal face at the right height. In day‑to‑day Aussie and Kiwi conditions—think sand, mud, wet-weather gear—good pedal pads are a quiet safety hero.

As part of servicing, it’s smart to check pedal pads at each service interval or about every 10,000 km. Look for hardening, cracks, tears, or ribbing worn smooth. If the rubber’s glossy or the pad can be twisted on the pedal, it’s time to swap it. Worn pads can be noted during WOF/RWC checks, so staying ahead avoids a knockback.

Replacement is quick and usually tool‑free. For automatic Exiga models, there’s one pad (brake), for manuals, there are two (brake and clutch). Genuine pads fit best and last well, but quality aftermarket pieces can be fine if they match the original profile.

• Clean: Wipe dirt and grit off the pad and pedal with mild detergent—harsh solvents can dry the rubber.
• Inspect: Check edges for splits and the face for flattened ribs.
• Replace: Peel off the old pad. Warm the new pad in hot water to soften, hook the top lip over the pedal, then roll it down until seated all around.
• Test: With dry and damp soles, press each pedal to confirm solid, non‑slip feel. Make sure floor mats are clipped down and clear of the pedal area.

If unsure which you’ve got, note that manuals have both brake and clutch pads, automatics have only the brake pad. Your VIN or build plate helps confirm the correct part number.

Popular questions

Does the 2011 Subaru Exiga accelerator have a replaceable pedal pad?
No. The accelerator is a moulded plastic pedal assembly, so there’s no separate rubber pad to replace. If the surface is damaged or slippery, the remedy is to clean it or replace the pedal assembly if wear is excessive.

How often should pedal pads be replaced on a 2011 Exiga?
There’s no fixed kilometre limit. Replace them whenever the rubber is cracked, hardened, or the ribs are worn smooth. For many drivers this can be every 3–8 years, depending on climate, footwear and driving load.

Are Exiga pedal pads shared with other Subarus?
Often, yes. The brake pedal pad is shared across several Subaru platforms from the same era. Always check by VIN or part number to make sure the profile matches your specific trim (manual vs automatic).