Your Selected Vehicle
Parts for your 2011 Holden Captiva 7-Exterior bulbs
Narva T-10mm W5W Premium Wedge Globe W2.1 X 9.5D 12V 5W Single Blister Pack - 17177BL
Explore 4WD & Adventure
2011 Holden Captiva 7 Exterior Bulbs
Based on the Holden Captiva CG Series II Owner’s Manual (2011) sections covering “Bulb replacement” and GM Global Service Information, the 2011 Captiva 7 is equipped with serviceable exterior bulbs for headlamps, indicators, stop/tail, reverse, fog and number plate lighting. This aligns with Australian and New Zealand road rules requiring compliant exterior lighting, so exterior bulbs are absolutely relevant to this model.
On a Captiva 7, the exterior bulbs (often called globes) handle two big jobs: helping the driver see the road and making sure everyone else can see the vehicle’s intentions. From dusk runs to rainy commutes, those headlamps, indicators and brake lights keep the SUV safe and compliant.
Typical exterior bulbs on a 2011 Captiva 7 include:
- Headlamps (low and high beam)
- Front and rear indicators, plus mirror-mounted side repeaters
- Tail and stop lamps, and the high-mount stop lamp
- Reverse lamp(s)
- Front and/or rear fog lamps (variant dependent)
- Number plate lamp(s) and front position/parking lamps
As part of routine servicing, it’s smart to check all exterior bulbs every six months, or before rego/WoF. A quick walk-around with the lights on—and a helper for brake and reverse—will catch a dud globe early. Replace any failed bulbs promptly and, where practical, in pairs (for consistent brightness and colour).
Always match the correct wattage and base type from the owner’s manual or a VIN-based parts catalogue. When fitting halogen bulbs, avoid touching the glass—skin oils can shorten globe life. If a new bulb fails quickly, look for contributing issues: moisture in the housing, a loose holder, poor earths, or charging voltage that’s too high.
After replacement, check beam aim and pattern against a wall and ensure the housing seals and dust caps are seated to keep moisture out. If lenses are hazy, consider a headlamp restoration to recover output. For LED upgrades, stick to ADR/ECE-compliant solutions and confirm local legality, many retrofit LEDs in halogen housings aren’t approved for road use.
Pro tip for road trips: carry a small kit of common bulbs and mini blade fuses in the boot. It’s cheap insurance and keeps the Captiva 7 ready for long-distance duty.
- What headlight bulb does a 2011 Holden Captiva 7 use?
Most 2011 Captiva 7 models use a halogen H7 globe for low beam and either H1 or H7 for high beam, depending on trim and build. Some variants use H11 for front fog lamps and W5W/T10 for small position lamps. Always confirm against the owner’s manual, the bulb chart under the bonnet, or a VIN-based parts catalogue before buying. - Are LED headlight replacements legal on a Captiva 7 in Australia or New Zealand?
Only if the bulbs or assemblies are specifically approved and compliant. Many drop-in LED globes used in halogen reflectors don’t meet ADR/ECE requirements for on-road use. Check local state or NZTA rules and choose compliant components, a complete approved LED housing or OEM-spec bulb type is the safest bet. - Why do exterior bulbs keep blowing on a Captiva 7?
Common culprits are vibration, moisture in the lamp, corroded connectors or poor earths, incorrect wattage, or high charging voltage. Inspect the housing seals, clean and tighten connections, verify alternator output, and use quality, correct-spec globes to restore reliability.
