Parts for your 2010 Toyota Fortuner-Pedal pads

2010 Toyota Fortuner pedal pads — purpose, care and replacement

Pedal pads are absolutely used on the 2010 Toyota Fortuner. Toyota’s Electronic Parts Catalogue (AN60 series, 2005–2015) lists “Pad, Brake Pedal” across all variants and “Pad, Clutch Pedal” for manual models. The Toyota Repair Manual specifies inspecting pedal rubber for wear, and Australian/New Zealand requirements (e.g., ADR 42/04 and WoF guidance) call for non‑slip pedal surfaces. On autos you’ll find a brake pedal pad, manuals add a clutch pedal pad. The accelerator typically uses a textured plastic face rather than a removable rubber pad.

On this Fortuner, the pedal pads give solid, non‑slip grip in the wet, dampen vibration, and protect the pedal arm from wear. That grippy rubber is a small but crucial safety item: once it’s glazed smooth or cracked, shoe traction drops and stopping distances can blow out because your foot might slip at the worst moment.

As part of regular servicing, it’s smart to include a quick pedal pad check. At each service interval, look for shiny, hardened rubber, cracks, curled edges, or grooves worn nearly flat. If any of that is present—or the pad can be twisted or lifted by hand—it’s time to replace. For manual Fortuners, give the clutch pad the same attention, especially if the vehicle tows or does lots of city kilometres.

Replacement is straightforward. Use a genuine Toyota “Pad, Brake Pedal” (and “Pad, Clutch Pedal” on manuals) or a reputable aftermarket equivalent matched to the AN60 Fortuner by VIN. Fit them dry—no sprays or lubricants—by hooking the top lip over the pedal plate and working the edges on by hand. After installation, press each pedal through its full travel and make sure floor mats are clipped down and clear. If the accelerator’s textured face is damaged, replace the pedal cover or assembly as specified for the variant rather than improvising a rubber overlay.

• Clean pads with mild soapy water, avoid silicone dressings that make them slippery.
• Inspect every service, replace at the first sign of glazing, cracking, or looseness.
• If anyone drives in wet boots or on the farm, check more often.

Simple part, big job: fresh, grippy pads help the Fortuner stop and shift exactly when asked.

Popular questions about 2010 Toyota Fortuner pedal pads

How often should pedal pads be replaced?
There’s no fixed kilometre limit, but many drivers see 3–8 years depending on footwear, climate, and use. Replace at the first sign of smooth glazing, cracking, or if the pad feels loose underfoot. If the Fortuner does heavy towing, off‑road work or lots of city stop‑start, expect faster wear.

Does an automatic Fortuner have a clutch pedal pad?
No. Auto variants have a brake pedal pad only. Manual models have both brake and clutch pedal pads. The accelerator is typically a textured plastic surface rather than a separate rubber pad.

Are Hilux and Fortuner pedal pads interchangeable?
Often, yes—the Fortuner shares its platform with the Hilux of the same era, and many pads cross over. Still, the safest bet is to match by VIN in the Toyota EPC or check the part number stamped on the old pad before ordering.