Parts for your 2010 Ford Mondeo-Wheel hubs

2010 Ford Mondeo wheel hubs — what they do and when to replace them

Wheel hubs are absolutely used on the 2010 Ford Mondeo. Technical sources including the Ford ETIS/Workshop Manual (Front Suspension and Rear Drive Axle sections), the Haynes Mondeo 2007–2014 manual, and SKF/Motorcraft hub and bearing catalogues identify hub-and-bearing assemblies front and rear on this model. The front typically uses a pressed-in bearing with a hub flange in the steering knuckle, while the rear is a bolt-on hub unit on disc-brake variants, each with an integrated ABS encoder.

On a 2010 Mondeo, the wheel hub is the solid foundation that the wheel bolts to. It supports the vehicle’s weight through the bearing, keeps the wheel running true, and provides the mounting face for the brake disc. The bearing is sealed-for-life, so there’s no greasing or adjustment—when it wears, the whole hub/bearing assembly is replaced. The ABS wheel speed signal is usually read from a magnetic encoder in the hub, so a failing hub can also trip the ABS light.

During routine servicing, it’s smart to check for play, roughness and noise. Spin each wheel and listen for a humming or growl that rises with speed, rock the wheel at 12 and 6 o’clock to feel for movement, and look for uneven tyre wear that could hint at bearing looseness. Because the bearings are sealed, any sign of wear means replacement rather than repair.

• Common symptoms: droning or rumbling that changes with road speed, play at the wheel, ABS light on, hot hub after a drive, or metallic swarf on the magnetic ABS pickup.
• Replacement tips: use quality hub assemblies, avoid striking the encoder surface, and always fit new single‑use fasteners (hub/drive shaft nut and hub bolts where specified). A press is needed for the front, the rear is typically bolt-on. Confirm torque specs in the Ford workshop manual.
• After care: road-test for noise, clear any ABS faults, and consider a wheel alignment if the knuckle was loosened.

There’s no set kilometre interval—many last well past 150,000 km—but once noise or play appears, prompt replacement protects tyres, brakes and CV joints. Done right, fresh hubs restore that smooth, quiet Mondeo ride Aussies and Kiwis expect.

How long do Mondeo wheel hubs usually last?

It varies with roads and loads, but many owners see 120,000–200,000 km. Frequent potholes, heavy towing, or oversized wheels can shorten life.

Can a bad hub cause ABS or traction control warnings?

Yes. The hub’s encoder supplies the wheel speed signal. If the bearing is loose or the encoder is damaged, the ABS/ESP light can illuminate and fault codes will log.

Should hubs be replaced in pairs?

It’s not mandatory, but if one side has failed due to wear, the opposite side is often close behind. Many techs recommend doing both sides on the same axle for consistent noise and feel.