Parts for your 2009 Toyota Crown-Oil filter

2009 Toyota Crown — Oil Filter

Technical sources confirm the 2009 Toyota Crown does use an engine oil filter. The Toyota Repair Manual for the S200-series Crown (GRS20x/URS20x) and the Toyota Electronic Parts Catalogue list a cartridge-style oil filter element for the 4GR‑FSE, 3GR‑FSE, 2GR‑FSE and 1UR‑FSE engines. Common genuine element kits include 04152‑YZZA1 for many GR engines and 04152‑38010 for certain UR V8 variants, the exact part number depends on the engine code.

For owners, that oil filter is a small bit of kit doing a big job. It traps fine contaminants—metal particles, soot and sludge—so clean oil can keep the Crown’s V6 or V8 happily lubricated. Clean oil reduces wear, keeps variable valve timing parts moving freely, and helps maintain fuel economy and smooth, quiet running.

As part of regular servicing, the oil filter on a 2009 Toyota Crown should be replaced at each engine oil change. In Australian and New Zealand conditions, that typically means every 10,000 km or 12 months—whichever comes first. If the car does lots of short trips, idling, hot-weather towing, or dusty, unsealed-road driving, bring that interval forward.

Most 2009 Crowns use a cartridge element inside an alloy housing. A good practice checklist looks like this:

• Confirm the engine code and select the correct element and O‑rings (the kit usually includes a large cap O‑ring and a small drain plug O‑ring).
• Warm the engine, then drain the sump. Use the housing’s drain feature if fitted to empty the filter canister before removing the cap.
• Lightly oil new O‑rings, seat them in their grooves, and install the new element.
• Refit the cap and tighten to the specified torque (around 25 N·m for many GR/UR housings, check the service manual for your exact spec).
• Refill with the correct grade and capacity of oil, run the engine, and check for leaks.

They’ll also want to keep an eye on tell-tales that the filter is overdue: oil looks pitch-black immediately after a change, ticking on cold starts, or the oil pressure warning flickering. Using a quality filter (genuine or reputable aftermarket matching OE spec) and replacing the crush washer on the sump plug helps avoid drips and pressure issues. A tidy, by‑the‑book filter change is cheap insurance for a long-lived Crown.

Popular questions about 2009 Toyota Crown oil filters

Which oil filter fits a 2009 Toyota Crown?
It depends on the engine. GR-series V6 models commonly use a cartridge element such as Toyota 04152‑YZZA1, while UR-series V8 variants can use 04152‑38010. Checking the build plate (engine code) or the VIN in a Toyota parts catalogue is the safest way to confirm the exact part.

How often should the oil filter be changed?
In AU/NZ conditions, change the filter with every oil service—about every 10,000 km or 12 months. If the vehicle sees lots of short trips, heavy traffic, hot climates, towing, or dusty roads, reduce the interval to keep the oil clean and the variable valve timing system happy.

Is the Crown’s oil filter a spin‑on or a cartridge?
Most 2009 Crowns use a cartridge-style element housed in an alloy canister. That means replacing the inner element and O‑rings rather than spinning off a full metal can. A cup-style filter wrench makes the job easier and helps torque the cap correctly.