Your Selected Vehicle
Parts for your 2009 Suzuki Splash-Struts
Clutch Industries Heavy Duty Clutch Kit Inc SMF - SRF2538NHD
Explore 4WD & Adventure
Clutch Industries 4Terrain Ultimate Heavy Duty Clutch Kit - 4TU3096N
Mantic 9000 Twin Plate Clutch - Sprung Centre Cushioned Organic - M924207
Clutch Industries Heavy Duty Clutch Kit With Sprung Cerametallic Clutch Plate - R326NHD-SSC
UniClutch Sport Core - 195mm UC2 Adaptive Fit Push Type - UC0824220
Mantic 9000 Twin Plate Clutch - Sprung Centre Cushioned Organic - M926207
4Terrain Ultimate 1400 Clutch Kit Inc Solid mass flywheel - 4TSRF2538NX-A
UniClutch Sport Core - 240mm UC2 Adaptive Fit Push Type - UC1024220
Clutch Industries Heavy Duty Clutch Kit With Sprung Cerametallic Clutch Plate - R1272NHD-SSC
Mantic 9000 Twin Plate Clutch - Sprung Centre Cushioned Organic - M924201
Clutch Industries Euro Dual Mass Replacement Clutch Kit Inc SMF - DMR2703N
Clutch Industries Heavy Duty Clutch Kit With Cushioned Ceramic Clutch Plate - R1132NHD-SSCC
Mantic 9000 Twin Plate Clutch - Sprung Centre Cushioned Organic - M926227
Clutch Industries Heavy Duty Clutch Kit With Cushioned Ceramic Clutch Plate - R1127NHD-SSCC
2009 Suzuki Splash struts: what’s fitted and how to keep them sweet
Based on technical documentation, the 2009 Suzuki Splash uses MacPherson struts on the front axle and a torsion-beam rear with separate shock absorbers, so front struts are absolutely relevant for this model. References: Suzuki Splash Service Manual (Chassis & Suspension, 2008–2012 editions), Vauxhall/Opel Agila B (the twin-model) factory service information, and aftermarket catalogues from KYB and Monroe that list complete front strut assemblies for 2008–2014 Splash/Agila applications.
On the Splash, the front MacPherson strut does double duty: it’s both a damper and a load‑bearing part of the suspension geometry. It supports the spring, keeps camber under control, and soaks up bumps so the little Suzuki tracks straight and feels settled. The top mount and bearing let the strut rotate with the steering, while the dust boot and bump stop protect it from grime and hard hits. When the struts are fresh, steering feel is tidy, braking distances are consistent, and tyres wear evenly—perfect for Aussie and Kiwi city runs and weekend missions.
As part of regular servicing, it pays to give the front struts a proper once‑over every 20,000 km or 12 months. Look for oil weepage, perished boots, cracked bump stops, or sloppy top mounts. A road test helps too: listen for clunks over speed humps, note any nose‑diving under brakes, or a floaty, boaty feel on the motorway. In local conditions—rough chip seal, speed humps, and the odd gravel lane—many Splash struts are ready for replacement somewhere around 80,000–120,000 km, but condition beats kilometres every time.
- Replace front struts in pairs to keep the car balanced.
- Always fit new strut mounts/bearings, boots and bump stops while it’s apart.
- Torque suspension bolts at ride height to avoid bush preload.
- Finish with a proper wheel alignment—camber and toe can shift when struts are changed.
- Inspect front springs for cracks or sag and replace if needed.
Done right, new front struts make the Splash feel tight and predictable again, improving safety, comfort, and tyre life without any drama.
Does the 2009 Suzuki Splash have rear struts?
No. The rear uses a torsion‑beam axle with separate coil springs and standard shock absorbers. Only the front axle uses MacPherson struts.
How often should the front struts be replaced?
There’s no fixed interval, but many owners see best results replacing around 80,000–120,000 km depending on road conditions and load. Inspect every service and decide on condition.
Do they need a wheel alignment after front strut replacement?
Yes. Changing struts can nudge camber and toe out of spec. A post‑fit alignment keeps steering feel spot on and protects tyre life.