Your Selected Vehicle
Parts for your 2009 Suzuki Splash-Headlight bulbs
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse/Reflector Mini Jumbo Twin Blister - 420ARRWM2
LED Autolamps 12V LED Boat Trailer Lamps Stop/Tail/Indicator with Licence Plate Lamp Light Left & Right Side, with 8m cable, Twin Blister - 209GARLP2/8M
LED Autolamps 12/24V Maxilamp Stop/Tail/Indicator/Reflector Single Lamp - MAXILAMP1XRE
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
Explore 4WD & Adventure
LED Autolamps LED Autolamps Indicator LED Light Round Amber Lens w/Rubber Grommet and Plug 12/24v - 110AMG
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflex Reflector 2 Pack - 151BAR2
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker RHS Multivolt - 805ARIMR
LED Autolamps Multi Fit Steel Bracket To Suit 280/282/275/80/283/284 Triple Combination Lamps - MFBKT
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12V Interior Strip lamp Touch Sensor Switch With MCU Circuitry - 40260SMCU
2009 Suzuki Splash headlight-bulbs
Based on technical sources – including the 2009 Suzuki Splash Owner’s Manual (lighting section), Suzuki’s electronic parts catalogue, and major bulb catalogues from Osram and Philips – the 2009 Splash uses conventional halogen headlight bulbs. Most 2009 models are specified for an H4 (12V, 60/55W) dual‑filament bulb handling both low and high beam. So, headlight-bulbs are absolutely relevant to this vehicle.
On a small city hatch like the Splash, the headlight bulbs do the heavy lifting for safe night driving and low‑light visibility. The H4 unit throws a broad, well‑defined dip beam for oncoming traffic and a clear high beam for open roads. As halogens age, they gradually lose brightness and shift colour, which can creep up on a driver without noticing until night vision takes a hit.
As part of routine servicing, it’s smart to inspect beam brightness and lens clarity, and consider replacing bulbs in pairs every couple of years or 30–50,000 kilometres, especially if there’s a lot of night or rural driving. Tell‑tale signs it’s time: dim or yellowish light, flickering, or one side failing. Sticking with the specified H4 60/55W avoids heat damage and electrical strain, and keeps the Splash compliant with ADR/ECE rules in Australia and New Zealand.
- Switch off the ignition, pop the bonnet, and let the lights cool.
- Reach the rear of the headlamp and peel off the rubber dust cap.
- Unplug the 3‑pin connector, release the spring clip, and withdraw the old bulb.
- Fit the new H4, aligning the tabs, avoid touching the glass. Clip it in, reconnect, and refit the dust cap.
- Test low and high beam, then check aim, adjust if needed per the manual.
Handy tips: replace both sides together for even colour and output, keep the dust caps seated to prevent moisture, and if bulbs fail early, have the battery/charging voltage checked. LED retrofit bulbs may seem tempting, but many are not road‑legal in reflector housings and can scatter light. If considering an upgrade, use ADR/ECE‑approved options or complete headlamp assemblies designed for LED/HID, and always verify local WOF/rego requirements. Market variations exist, so if in doubt check the owner’s handbook or the markings on the lamp housing.
What headlight bulb type fits a 2009 Suzuki Splash?
Most 2009 Splash models take an H4 halogen bulb rated at 12V 60/55W for combined low/high beam. Some market or trim variations exist, so it’s wise to confirm via the owner’s manual or the markings on the lamp cover before buying.
How often should the bulbs be replaced?
Halogen bulbs commonly fade over 2–3 years. Replacing in pairs every 30–50,000 kilometres keeps the beam even and bright. If one fails, the other is usually not far behind.
Can they switch to LED bulbs?
It’s possible, but many LED retrofits aren’t road‑legal in halogen reflector housings and can create glare. If upgrading, choose ADR/ECE‑approved solutions and check local WOF/rego rules to stay compliant.