Your Selected Vehicle
Parts for your 2009 Subaru Tribeca-Batteries
LED Autolamps 12V Slimline/Low Profile Reverse Lamp with Black End Caps - 285BW12
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflex Reflector White Background - 150BAR
LED Autolamps Stop/Tail/Indicator Diffused Tail Function With Sequential Indicator - 520ARRMB
LED Autolamps 355 Series Multi Volt Black Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Twin Blister Pack - 355BARWM-2
Explore 4WD & Adventure
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Blister Pack - 235ASEQ-2
LED Autolamps 12/24V 280 Mini Jumbo Stop/Tail/Indicator Lamp Blister Pack - 280ARRM
LED Autolamps Twin function side indicator with amber side marker - 97CAIMCSB
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Bulk Packaging - 235ASEQB
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reflector Light 28cm Cable Blister Pack - 275MAR
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps 12V Stop/Tail/Ind/Rev LED Light Kit 450mm Loom DT04 Connector - SO282ARWM2LR450
LED Autolamps 12/24V Stop/Tail/Indicator/Reflector With Licence Plate Lamp - 99ARLM
LED Autolamps 12V Front Indicator/Marker Lamp 80mm Round Blister Pack - 80AW
LED Autolamps 10/30V LED Side Direction Indicator Light With 3m Tinned Cable - 58AM3
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp With Inbuild Reflectors - 283ARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Lamp With Reflex Reflector Blister Pack 1 pce - 150ARM
2009 Subaru Tribeca batteries
Technical sources including the 2009 Subaru Tribeca Owner’s Manual and Subaru’s Factory Service Manual (Starting/Charging System sections), plus the scheduled maintenance guide, confirm this model is fitted with a 12‑volt lead‑acid starter battery. So yes—batteries are absolutely relevant to the 2009 Subaru Tribeca.
The battery’s job is bigger than just cranking the flat‑six to life. It stabilises system voltage for the ECU, powers lights and accessories with the engine off, and keeps security and memory functions alive. When it’s healthy, starting is quick, electronics behave, and the alternator isn’t overworked catching up after each drive.
As part of routine servicing, a battery test is a smart inclusion—checking open‑circuit voltage, conductance/CCA, and a charging system test under load. In Australian and New Zealand conditions, most Tribeca batteries last around 4–6 years, shorter if the vehicle does lots of short trips, towing, or sits for long periods. Keep terminals clean and tight, ensure the hold‑down is secure, and if the unit is serviceable (not sealed), electrolyte should sit above the plates with distilled water only.
When replacement time comes, match the physical size, terminal layout, and at least the original cold‑cranking amps. A quality AGM is a worthwhile upgrade if the car runs plenty of accessories, but a good flooded lead‑acid that meets spec is perfectly fine. Avoid “stop/start” EFB types—this model doesn’t use idle stop systems. Use a memory saver if you want to keep presets, otherwise, expect to reset the clock and radio, and the auto windows may need a quick relearn. The ECU may refine idle and fuel trims over a few short trips.
- Signs it’s due: slower cranking, dimming lights at idle, repeated jump‑starts, or test results below spec.
- Safe swap basics: ignition off, remove negative first, then positive, install positive first, then negative, lightly grease terminals, verify charging voltage ~13.8–14.6 V with engine running.
- Not driving often? A smart maintainer keeps charge without cooking the battery.
- Always recycle the old unit—most parts stores and workshops take them.
Popular questions about 2009 Subaru Tribeca batteries
What battery type and size suits a 2009 Subaru Tribeca?
It takes a 12‑volt automotive lead‑acid battery. Choose one that matches the tray size and terminal orientation, with CCA at least equal to the original spec. Many owners opt for a quality AGM for better vibration resistance, though a conventional sealed lead‑acid that meets the rating works well. When in doubt, check the owner’s manual or the label on the existing unit.
How long should the battery last?
Typically 4–6 years in AU/NZ. Heat, short urban trips, and added accessories can shorten life. After three years, add a battery test to each service so issues are caught before it leaves them stranded at the servo or school run.
Will anything need resetting after a battery change?
Usually just the clock, radio presets, and auto window functions. The engine control module will fine‑tune idle and fuel trims over a few drives, which is normal. If a memory saver is used during the swap, most settings are retained.