Your Selected Vehicle
Parts for your 2009 Subaru Exiga-Interior bulbs
Explore 4WD & Adventure
Narva Marine 12V Saturn Dual Colour 75mm LED Interior Lamp with Touch Switch (White/Red) - 87501WRBL
Narva Marine 12V Saturn Dual Colour 130mm LED Interior Lamp with Touch Switch (White/Red) - 87503WRBL
2009 Subaru Exiga interior bulbs: what they do and how to look after them
Interior bulbs are definitely fitted to the 2009 Subaru Exiga (YA series). Subaru’s 2009 Exiga Owner’s Manual (Lighting section), the factory FAST parts catalogue, and the Electrical/Illumination section of the Subaru service manual all list serviceable room, map, vanity, and luggage compartment lamps with replaceable bulbs. So, yes—interior bulbs are relevant and used on this model.
Inside the Exiga, these little globes do a big job. They light the cabin for buckling the kids in at night, help find gear in the boot, and make map reading or plugging in a charger less of a fumble. Typical fittings in the Exiga include dome and map lights up front, a second-row lamp, a luggage/boot lamp, and often vanity mirror lights. Depending on position, Subaru uses common wedge (T10/W5W) or festoon-style bulbs, as noted in the owner’s manual and parts listings.
When it’s service time—or if a light’s gone dim or dead—it’s worth giving the interior bulbs a once-over. Use the correct wattage to avoid heat-damaged lenses and patchy lighting. If swapping to LEDs, pick quality, CANbus-friendly units that play nicely with Subaru’s fade/dimmer circuit, cheap LEDs can flicker or glow faintly when “off”. Keep a warm white colour if you want a factory look, or cool white for a modern vibe. Either way, mind polarity on LEDs and test before refitting the lens.
Simple care goes a long way: clean lenses with a soft cloth so the light output stays bright, and check contacts for corrosion—especially in the tailgate area where moisture can sneak in. If bulbs keep blowing, double-check you’re not over‑wattaging and that the door switches and dimmer circuit are behaving. During a routine service or a WOF/rego check, a quick interior lighting test adds a bit of everyday convenience for the driver and the family.
- Switch everything off and let hot bulbs cool.
- Use a plastic trim tool to pop the lens without cracking it.
- Note the bulb style and rating, match like-for-like.
- Fit the new bulb, test operation (including fade/door-ajar), then refit the lens.
- If working near airbags or using metal tools, disconnect the negative battery terminal.
What bulb types does the 2009 Exiga use inside?
It’s a mix of wedge (T10/W5W) and festoon bulbs across dome, map, vanity, and luggage lamps. Exact styles can vary by trim and market. The Subaru Exiga Owner’s Manual and the FAST parts catalogue list the correct styles and wattages. When in doubt, pull the old bulb and match by base and length.
Can the interior bulbs be upgraded to LED without issues?
Yes, many owners upgrade to LED for brighter, crisper light and lower draw. Choose quality, CANbus-friendly LEDs to prevent faint glowing or flicker with Subaru’s fade circuit. Check polarity, test before refitting, and avoid over-bright units that can be harsh in a small cabin.
Why do interior bulbs keep blowing in my Exiga?
Common causes include using the wrong wattage, poor-quality bulbs, vibration (especially in the tailgate lamp), corroded contacts, or moisture in the lens. Fix the root cause—clean contacts, replace a cracked lens seal, and use the correct-spec bulb. If multiple bulbs fail often, have charging voltage checked during a service.
