Parts for your 2009 Nissan Navara-Oil filter

2009 Nissan Navara Oil Filter

The 2009 Nissan Navara (D40) is fitted with an engine oil filter on all factory engines, including the YD25DDTi 2.5 turbo‑diesel and the VQ40DE 4.0 petrol. This is documented in the Nissan Navara D40 Service Manual (Engine Mechanical – Lubrication System), the 2009 Owner’s Manual maintenance schedule (which lists “engine oil and oil filter” replacement), and Nissan’s genuine parts catalogues that specify matching oil filter part numbers for these engines.

On a 2009 Navara, the oil filter’s job is simple but critical: keep the engine oil clean by trapping metal particles, soot, and other grime before they circulate through bearings, cam lobes, and—on diesels—the turbocharger. Cleaner oil means less wear, steadier oil pressure, and happier cold starts. The Navara’s filter is a spin‑on type, so it’s quick to replace during a routine service.

For everyday use in Australia and New Zealand, it’s smart to change the oil filter at every oil change—typically every 10,000 to 15,000 kilometres, or 6 to 12 months, whichever comes first. If the ute tows, does lots of short trips, idles on job sites, or sees dusty off‑road work, shorten those intervals. The Owner’s Manual intervals and the D40 Service Manual guidance are the go‑to references for your exact engine and conditions.

When replacing the filter, warm the engine, drain the oil, and spin off the old filter. Check the old rubber gasket isn’t stuck to the housing. Lightly oil the new filter’s seal, then fit it hand‑tight—usually until the seal contacts, plus a further partial turn as indicated on the filter body. Refill with the correct grade oil for your engine, start the engine, check for leaks, and re‑check the level after a few minutes. Pre‑filling the filter can help reduce dry start time on some diesel setups where access allows.

Choose a quality filter—genuine Nissan or a reputable aftermarket brand that meets or exceeds OEM spec. Using the correct filter for the specific engine (YD25DDTi vs VQ40DE) matters, the anti‑drainback valve, bypass pressure and thread spec must match to protect the engine properly.

• Watch for warning signs: oil pressure light flicker, ticking on start‑up, leaks around the filter, or metallic sheen in drained oil.
• Dispose of used oil and filters responsibly at a local recycling facility.

What oil filter type fits a 2009 Nissan Navara?

It uses a spin‑on engine oil filter. Fitment depends on the engine (YD25DDTi diesel or VQ40DE petrol), so match by VIN or engine code. Genuine Nissan filters and quality aftermarket equivalents are widely available for D40 models.

How often should the oil filter be changed?

Change the oil filter at every oil change—generally 10,000–15,000 km or 6–12 months. If towing, off‑roading, or doing lots of short trips, service it sooner to keep the oil clean and the turbo and bearings well protected.

Can the filter be changed without changing the oil?

It’s not ideal. Swapping the filter alone can introduce air and mix old and new oil. The best practice is to replace the filter with the oil so everything is fresh, sealed properly, and leak‑checked in one go.