Parts for your 2009 Mitsubishi Outlander-Manifold gasket

2009 Mitsubishi Outlander manifold gasket — what it does and when to sort it

Per Mitsubishi Motors factory service information for the 2009 Outlander (engines 4B12 2.4L and 6B31 3.0L) and OEM parts catalogues used by dealers, this model is fitted with both intake-manifold and exhaust-manifold gaskets. So yes, a manifold-gasket is relevant and used on the 2009 Mitsubishi Outlander.

A manifold gasket seals the join between the engine and its manifolds. On the intake side it keeps unmetered air from sneaking in, protecting idle quality, fuel trims and cold-start manners. On the exhaust side it keeps hot gases in the headers where they belong, preserving low-end torque, keeping the cabin free of fumes, and protecting nearby components. Without healthy gaskets, the Outlander can feel a bit gutless off the line, run lean, or get noisy under load.

For the 2009 Outlander specifically, the intake-manifold gasket is a precision, heat-resistant seal that copes with vacuum and temperature cycling. The exhaust-manifold gasket lives a much tougher life, sealing pulsating, super-heated gas — any leak there quickly sounds like a ticking under the bonnet and can toast oxygen sensors upstream.

These gaskets aren’t a scheduled replacement item, but they’re considered single-use whenever a manifold is removed. On the 3.0L V6, the upper intake comes off for rear spark plugs, so new intake-manifold gaskets are good practice at that service. On both engines, fresh exhaust-manifold gaskets are a must if the manifold is off for stud, cat, or heat-shield work.

• Signs it’s time: whistling or hissing at idle, rough idle and lean codes, exhaust ticking on cold start, sulphury exhaust smell in the cabin, black sooty marks at the manifold flange, or a sudden drop in fuel economy.
• What to do: pressure/smoke test the intake for leaks