Parts for your 2009 Honda Elysion-Oil filter

2009 Honda Elysion Oil Filter — What It Does and When to Replace It

Based on Honda’s technical literature—namely the 2009 Elysion (RR) service information, Honda’s Electronic Parts Catalogue, and engine manuals for the K-series (K24A) and J-series V6 (J30A/J35A)—the 2009 Honda Elysion absolutely uses an engine oil filter. Both the 2.4‑litre four and the V6 variants take a spin‑on filter, with common Honda OEM part numbers including 15400‑PLM‑A02 and 15400‑RTA‑003. So yes, an oil filter is relevant and fitted as standard equipment on this model.

For anyone keeping a 2009 Elysion running sweet in Aussie or Kiwi conditions, the oil filter is the quiet achiever. It traps fine metal particles, carbon, varnish and dust that circulate as oil cleans and cools the engine. A healthy filter helps maintain stable oil pressure, reduces wear on bearings and cam surfaces, and supports consistent VTEC operation where fitted—handy for both city schleps and highway hauls.

As part of routine servicing, it’s smart to replace the oil filter at every oil change. For typical use, that’s about every 10,000 kilometres or 12 months—whichever comes first. If the Elysion spends a lot of time in stop‑start traffic, tows, idles for long periods, or drives in dusty, hot conditions, shorten the interval. Fresh oil with a fresh filter is cheap insurance against sludge and premature engine wear.

• Always choose a quality filter with the correct thread, gasket size and bypass/anti‑drainback valve design. OEM Honda (15400‑PLM‑A02 or 15400‑RTA‑003) or a reputable equivalent is the safe bet.
• Pre‑fill the filter if access allows, and lightly oil the rubber gasket before spinning it on.
• Tighten by hand until the gasket seats, then an additional 3/4 turn, or torque to about 12 N·m if a spec is provided and access permits.
• After starting, check for leaks and confirm oil pressure light goes out promptly.
• Dispose of the old oil and filter responsibly at a recycling facility.

Watch for signs a filter may be past its best: a flickering oil pressure light at idle, noisier valvetrain on cold starts, or oil that looks unusually dirty soon after a change. If in doubt, swap it out—especially before long trips.

Whether the 2009 Elysion carries the 2.4 K24A or the smooth J‑series V6, a good filter and sensible service intervals keep it running quietly and efficiently for the long haul.

Popular questions

What oil filter does a 2009 Honda Elysion use?
The 2009 Elysion uses a spin‑on oil filter. Common Honda OEM numbers include 15400‑PLM‑A02 and 15400‑RTA‑003. Quality aftermarket equivalents that meet or exceed OEM specs are fine, provided they match the correct dimensions and valve settings for the K24A or J‑series V6.

How often should the oil filter be changed?
In Australia and New Zealand, a sensible interval is every 10,000 km or 12 months with the engine oil, whichever comes first. For heavy city use, towing, dusty roads, or frequent short runs, change the filter more often.

Can a larger or “performance” oil filter be fitted?
While some enthusiasts use larger filters, sticking with the OEM‑specified size and bypass setting is safest. A mismatched filter can delay oil pressure on cold starts or bypass too early. If upgrading, choose a reputable brand specifically cross‑referenced for the Elysion’s engine.