Parts for your 2008 Toyota Wish-Exhaust mount

2008 Toyota Wish exhaust mount — what it is, what it does, and when to replace it

Yes, an exhaust mount is absolutely used on the 2008 Toyota Wish. Toyota’s own service literature for the ZNE10/ANE10 series (first-gen Wish up to 2009) shows the exhaust system supported by multiple rubber hangers/mounts and brackets along the intermediate pipe and rear muffler. The Toyota Electronic Parts Catalogue also lists “Hanger, Exhaust Pipe” items for these models, and common aftermarket catalogues likewise supply rubber exhaust mounts for the 2003–2009 Wish range. So it’s a standard, relevant part on this vehicle.

On the Wish, these rubber mounts suspend the exhaust so it sits at the right height and angle, isolates vibration from the cabin, and gives the system room to expand and move without rattling. Over time, the rubber can harden, crack, or stretch, especially in Aussie and Kiwi conditions where heat, UV, coastal air, and road grime can be pretty tough on rubber. When the mounts get tired, the muffler can sag, the pipe can knock over bumps, and joints can be put under stress that leads to leaks.

For servicing, it’s worth giving the mounts a quick look any time the car’s up for an oil change or every 10,000–15,000 kilometres. If they’re perished, torn, or elongated, swap them out. There’s no fixed replacement interval, it’s condition-based, but many owners see 5–10 years from the originals depending on use and climate.

• Common signs it’s time: clunks over bumps, a droopy tailpipe, excess exhaust movement by hand, or a new buzz/vibration at idle.
• Good practice: replace in pairs or across the section you’re working on, so the system sits evenly.
• Fitting tips: let the exhaust cool fully, support the muffler with a jack stand, a spritz of silicone spray helps old rubbers slide off and new ones on, check brackets for rust and tighten fasteners after the car settles.
• Parts choice: OEM-style rubber keeps noise and harshness low. Firmer polyurethane is an option if the exhaust is aftermarket and needs extra support, but it can transmit more vibration.

The 2008 Wish typically uses several mounts from the centre section back to the rear muffler, exact count can vary by engine and drivetrain. If the exhaust has been modified in the past, consider replacing any oddball hangers so the system is properly supported again.

How many exhaust mounts does a 2008 Toyota Wish have?

Most 2008 Wish variants run three to four rubber hangers from the mid-pipe to the rear muffler. The exact number and shape can vary with engine and whether the car is 2WD or 4WD. A quick look under the rear half of the car will usually spot them near the muffler and just ahead of it.

Can polyurethane hangers be used instead of rubber?

Yes, firmer polyurethane hangers can help control movement on cars with heavier or aftermarket exhausts. On a stock Wish, OEM-style rubber is usually best for comfort. If you go poly, expect a touch more vibration at idle and over bumps.

What noises point to failing exhaust mounts?

Listen for a dull clunk over bumps, a metallic knock when starting or shutting down, or a new droning/buzz at certain revs. If you can move the tailpipe by hand more than a few centimetres, or the muffler looks crooked, the mounts are likely due.