Parts for your 2008 Mitsubishi Outlander-Pedal pads

2008 Mitsubishi Outlander pedal-pads — what they are, and when to replace them

Based on Mitsubishi Motors’ Outlander CW (2007–2012) Service Manual (Brake and Clutch sections) and the Mitsubishi ASA electronic parts catalogue for CW5W/CW6W, the 2008 Outlander is factory-fitted with removable rubber pedal pads on the brake pedal (all models) and on the clutch pedal (manual-transmission models). The accelerator on this generation uses an integrated plastic/metal tread and typically does not have a separate rubber pad. So yes—pedal pads are relevant and used on the 2008 Mitsubishi Outlander.

On a 2008 Mitsubishi Outlander, the pedal pads are the grippy rubber covers fitted over the brake pedal—and the clutch pedal on manuals—that keep the driver’s foot planted, even in the wet. They also dampen vibration, provide a consistent pedal height and feel, and help the vehicle pass WOF/RWC inspections by meeting basic safety expectations for pedal condition.

As part of routine servicing, it’s smart to inspect these pads every 10,000–15,000 km or at each service. Rubber hardens and wears with age, especially in Aussie heat or with sandy, muddy boots common across NZ and regional Australia. If the surface looks shiny, cracked, smooth, or the ribs are worn down, it’s time to replace. Slippery pedals are more than annoying—they’re unsafe and can trigger a WOF/RWC fail.

• Common signs it’s due: foot slips under light braking, visible cracks, edges curling, missing chunks, or a pad that’s loose on the pedal plate.
• Avoid silicon dressings and greasy cleaners—use mild soap and water only. Keep floor mats clipped so they don’t ride up under the pedal.

Replacement is a quick, DIY-friendly job. Warm the new rubber pad slightly (sunlight or warm water), then hook the pad’s lip over the metal pedal plate and work it on evenly until the groove is fully seated all the way around. A quality OEM-equivalent pad ensures the right thickness and grip, keeping pedal height and feel as Mitsubishi intended.

For manuals, replace the clutch pad at the same time as the brake so both pedals feel consistent. If the accelerator tread is damaged, the whole pedal assembly is typically replaced, as it usually isn’t a separate rubber pad.

Popular questions

Does the 2008 Outlander have pedal pads on all pedals?
All 2008 Outlanders have a rubber brake pedal pad. Manual models also have a clutch pedal pad. The accelerator uses an integrated tread without a separate rubber pad.

How often should the pedal pads be replaced?
There’s no fixed interval—replace on condition. Inspect at every service, many vehicles need new pads somewhere between 60,000–100,000 km, sooner if exposed to heat, grit, or heavy use.

Can aftermarket metal pedal covers be fitted?
They can, but they must be secure, non-slip, and not interfere with pedal travel. Check ADR compliance (AU) and WOF requirements (NZ) to avoid roadworthiness issues.