Parts for your 2007 Toyota Kluger-Egr valve

Does the 2007 Toyota Kluger have an EGR valve?

Short answer: an EGR valve isn’t fitted to the 2007 Toyota Kluger sold in Australia and New Zealand. The 2007 Kluger (GSU40/45 series) runs Toyota’s 3.5‑litre 2GR‑FE petrol V6, and Toyota’s own technical literature lists no external EGR system on this engine for our market. That’s backed up by the Toyota New Car Features (NCF) and Repair Manual engine control diagrams for the 2GR‑FE, which omit any EGR components, and by the Toyota Electronic Parts Catalogue (EPC) for the GSU40/45 Kluger, which contains no EGR valve or EGR pipe part listing for these models.

Why no EGR? The 2GR‑FE meets ADR 79/01 (Euro 4–equivalent) emissions targets without needing a traditional exhaust‑gas recirculation valve. Instead, it leans on:

• Dual VVT‑i to create “internal EGR” via valve overlap, trimming NOx formation directly in‑cylinder.
• Wide‑range air‑fuel ratio sensors and a three‑way catalytic converter to clean up what’s left.
• (On some variants) a Secondary Air Injection system to light off the cat quickly on cold start.

All that means there’s no external EGR valve to service, replace or clean on a 2007 Kluger in AU/NZ. That also means common “EGR” symptoms people read about online—like clogged EGR passages—don’t apply here. If a scanner is showing an EGR‑related code (for example, P0401) on this model, it’s usually a scan‑tool selection error or a generic code list, not a real Kluger fault. For drivability issues like pinging, rough idle or higher NOx on a 2GR‑FE, the smart checks are throttle‑body cleanliness, MAF contamination, vacuum leaks, PCV function, fuel quality, injector spray pattern, and ignition health (plugs and coils).

Technical sources referenced:

• Toyota New Car Features (NCF) for vehicles equipped with the 2GR‑FE V6: emission control overview shows no external EGR system.
• Toyota Repair Manual/Engine Control System (2GR‑FE): system diagrams and component lists do not include EGR valves, pipes or EGR control.
• Toyota Electronic Parts Catalogue (EPC) for Kluger GSU40/45 (2007): no EGR valve assembly listed.

Bottom line for owners: there’s no EGR valve on the 2007 Kluger to maintain. Keeping the intake tract and sensors clean, using quality fuel, and staying on top of scheduled servicing will deliver the emissions and performance the 2GR‑FE was designed for—without the extra plumbing of an EGR system.

Popular questions

Where’s the EGR valve located on a 2007 Toyota Kluger?
It isn’t—this model doesn’t use an external EGR valve. If you’re chasing an EGR component based on generic online guides, you won’t find one on the AU/NZ‑spec 2GR‑FE Kluger.

Can a 2007 Kluger throw an EGR code?
Not under normal conditions. The engine ECU for the 2GR‑FE in this model doesn’t monitor an EGR system because there isn’t one. If an EGR code pops up, double‑check the scan tool’s vehicle profile and code list, look instead for faults related to airflow, fuel trim, or ignition.

What should be serviced instead of an EGR valve on a 2GR‑FE?
Focus on the throttle body, MAF sensor, PCV valve, spark plugs and coils, and inspect for vacuum leaks. These items influence emissions and drivability on this engine far more than any non‑existent EGR hardware.