Your Selected Vehicle
Parts for your 2007 Subaru Outback-Headlight bulbs
Repco 12V LED Rear Combination Lamp Stop / Tail / Indicator Pair 100x100x25mm - RLT100BL2S3
Repco PY21W Bayonet Amber Globe 12V 21W BAU15s Pack of 2 - R384BLL
Explore 4WD & Adventure
Repco Wireless 1.5M Trailer Board With Rear Combination Lights 20 Metre Range - RTBW
Repco by Century Car Battery Ultimate Performance 360CCA - NS40ZX MF
Repco by Century Car Battery Ultimate Performance 530CCA - 68 MF
OEX Rear LED Combo Taillight 12V - Stop/Tail/Reverse/Indicator/Reflector - LLX94013
Repco by Century Car Battery Ultimate Performance 360CCA - NS40ZSX MF
Repco by Century Car Battery 4x4 & SUV Superior Performance 600CCA - NS70L MF
Narva H7 12/24V LED GEN III Headlight Bulb Conversion Kit Twin Pack - 18447
OEX Mini Relay 12V 4 Pin Normally Open 40A - Resistor Protected, Sealed - ACX1939RBL
Repco by Century Car Battery Ultimate Performance 430CCA - NS60X MF
Projecta 12V 1500A Intelli-Start Emergency Lithium Jump Starter and Power Bank - IS1500
Repco by Century Car Battery Superior Performance 400CCA - NS60LS MF
Repco by Century Car Battery Reliable Performance 480CCA - 58 MFR
2007 Subaru Outback headlight bulbs — what they do and how to look after them
Headlight bulbs are absolutely used on the 2007 Subaru Outback. Technical references such as the 2007 Subaru Outback owner’s manual, Subaru service information, and major lamp catalogues (Philips and Osram) list replaceable headlight bulbs for this model. Most AU/NZ 2007 Outbacks run halogen low beams (H7, 55 W) and high beams (HB3/9005, 60 W). Some higher trims may have factory HID/Xenon low beams (D2S) with a separate halogen high beam. So yes—this Outback is built around serviceable headlight bulbs, not sealed-beam units.
The headlight bulbs provide the primary forward lighting—low beam for everyday driving without dazzling oncoming traffic and high beam for open-road visibility. As bulbs age, light output drops and colour shifts, which can quietly hurt night-time safety well before a lamp actually fails. Keeping them fresh helps with roadworthy/WOF checks and keeps the Outback safe on rural and suburban runs alike.
For regular servicing, it’s smart to replace bulbs in pairs to keep the beam pattern and brightness consistent left to right. Halogen bulbs typically last a few years depending on use and vibration, HID capsules often go longer but do fade over time. After installation, a quick aim check is worthwhile to avoid glare and to make sure the light lands where it should.
- Confirm types before buying: commonly H7 low beam and HB3/9005 high beam, some trims use D2S HID low beam.
- Don’t touch the glass of halogen or HID—use gloves, skin oils shorten bulb life.
- Switch the lights off and let things cool, disconnect the battery if access is tight under the bonnet.
- For HID systems: high voltage—if unsure, have a qualified tech handle it.
- After fitting, check beam aim against a wall or get it checked during service.
Owners notice dim, yellowish light, flicker, or intermittent operation as signs it’s time. If one side fails, the other is usually not far behind. During routine servicing, a quick output and pattern check, plus verifying the headlight lenses are clear and free of haze, keeps the 2007 Outback shining as it should.
Popular questions about 2007 Subaru Outback headlight bulbs
What bulb sizes fit a 2007 Subaru Outback?
Most 2007 Outbacks in Australia and New Zealand use H7 (55 W) for low beam and HB3/9005 (60 W) for high beam. Some higher-spec variants may run HID/Xenon D2S low beams with a separate halogen high beam. Always check the owner’s manual or the markings on the lamp housing to confirm, as trims and markets can vary.
How often should the bulbs be replaced?
Replace them when output drops, the colour shifts, or a globe fails. Halogen bulbs often benefit from renewal every 2–4 years depending on use, HID capsules last longer but gradually dim. Replacing in pairs keeps the light balanced and helps maintain a clean beam pattern.
Are LED replacement bulbs legal for this model?
In AU/NZ, fitting LED retrofit bulbs into halogen housings isn’t always road-legal unless the assembly is approved to the relevant ADR or NZ lighting rules. Even if they fit, the beam pattern and glare control can be off. For legal road use, stick with compliant halogen or factory HID, or upgrade with approved components and aim checks. When in doubt, confirm with local regulations and your inspector.