Parts for your 2007 Ford Mondeo-Exhaust mount

2007 Ford Mondeo exhaust mount — what it does and how to look after it

Technical sources confirm the 2007 Ford Mondeo uses exhaust mounts (rubber exhaust hangers/insulators) throughout the system. Ford’s ETIS workshop manual (Exhaust System – General Information), the Ford Microcat/ECAT parts catalogue, and the Haynes Ford Mondeo 2007–2014 manual all show multiple rubber mounts supporting the front pipe, centre section and rear muffler assemblies. So yes, an exhaust mount is absolutely fitted and relevant on a 2007 Mondeo.

The exhaust mounts hold the exhaust in the right place while soaking up vibration so it doesn’t buzz through the cabin. They also let the system move a bit as it heats and cools, which protects welds, the flex joint, turbo/downpipe on diesels, and nearby brackets. When the rubber ages, perishes or stretches, the exhaust can sag, knock on the underbody, or sit skew-whiff in the bumper cut-out.

Common signs of a tired mount include a clunk over bumps, a droney note at certain revs, visible cracks in the rubber, elongated holes, or a tailpipe that’s sitting low or touching the valance. Ignoring failed mounts can load up the flex section or manifold studs and end up costing a lot more than a few inexpensive hangers.

• Service check: Have the mounts inspected at each service (about every 15,000–20,000 kilometres). Look for cracking, hardening from heat, oil contamination, or excessive movement. Compare left/right muffler height.
• Replacement tips: Support the exhaust with a stand or jack and wood block, spray soapy water or silicone on the hanger, then lever the old rubber off. Fit the new mount in the same orientation. Replacing mounts in pairs helps keep alignment even.
• Parts choice: Use OEM or OEM-quality rubber. Some diesel/DPF variants use specific mounts near the centre section—match by VIN. Polyurethane options exist but can add NVH.
• After-fit checks: Ensure 10–15 mm clearance around the pipe, heat shields intact, and no contact with the subframe or bumper. Recheck after a few heat cycles as the system settles.

Time and cost are modest—often 10–30 minutes per mount and relatively low parts pricing. Most 2007 Mondeos will have several mounts from the front section through to the rear silencer, with exact count varying by body style and engine. Keeping them fresh helps the Mondeo stay quiet, tidy, and stress-free underneath.

Popular questions about 2007 Ford Mondeo exhaust mounts

How many exhaust mounts does a 2007 Ford Mondeo have?
Most have three to five, depending on body style (hatch, sedan, wagon) and engine. Expect one near the front/centre, one around the mid-section, and one or two at the rear muffler. Wagons and some diesel models may use an extra rear or centre mount for added support.

What are the signs an exhaust mount needs replacing?
Knocking from under the car, a droney exhaust note, sagging or off-centre tailpipe, or visible cracks and stretched holes in the rubber. If the exhaust hits the body or bumper, sort it promptly to avoid damage to the flex joint or heat shields.

Can a Mondeo owner replace exhaust mounts at home?
Often, yes. With stands, basic spanners, and some silicone spray or soapy water, the rubbers can be swapped fairly quickly. If brackets are rusted, or access is tight around the DPF/turbo area on diesels, a workshop may be the safer bet.