Parts for your 2006 Toyota Avensis-Exhaust mount

2006 Toyota Avensis Exhaust Mounts — What They Do and When to Replace

Yes, the 2006 Toyota Avensis (T25 series, 2003–2008) absolutely uses exhaust mounts. Technical references that confirm this include the Toyota Electronic Parts Catalogue (EPC), which lists several “insulator, exhaust” rubbers for this model (common part numbers include 17565-0H010, 17565-0H020 and 17565-0H030), and the Toyota Avensis T25 workshop/repair manual, which specifies removal and installation procedures for exhaust “insulators” (rubber hangers). Major aftermarket catalogues such as Bosal and Walker also show dedicated rubber hangers for the Avensis of this era. So an exhaust-mount is not only relevant — it’s essential on this car.

On a 2006 Avensis, exhaust mounts (often called rubber hangers or insulators) suspend the exhaust system from the underbody. They isolate vibration, keep the pipework and mufflers centred in the tunnels, and allow controlled movement as the engine shifts under load and the system heats and cools. Good mounts prevent knocks over bumps, reduce cabin drone, and stop stress cracks in welds and flanges.

As part of regular servicing, it’s smart to give the exhaust mounts a once-over. Rubber naturally hardens and perishes with heat and age. If the tailpipe is sitting off-centre, rattles on start-up, thuds over speed humps, or you can easily move the system by hand more than a couple of centimetres, the mounts may be tired.

• Inspection tips: look for splits, elongation of the holes, glazed or cracked rubber, and missing brackets.
• Replacement pointers: support the exhaust with a stand, spritz the old mounts with silicone spray, and lever them off carefully. Fit quality OE-spec or reputable aftermarket rubbers to maintain the correct durometer (hardness).
• Good practice: replace mounts in pairs or as a set if they’re the same age, check adjacent heat shields, and verify clearances around the rear bumper and suspension arms.

There are typically several mounts on the Avensis — usually one near the front pipe area, one or two around the centre section, and one or two at the rear muffler, depending on engine and body style. Most owners will see 80,000–120,000 km before the first replacement, but high heat cycles, towing, or rough roads can shorten that. Keeping the mounts fresh protects the rest of the exhaust, helps it sit correctly, and keeps things quiet and compliant — very on-brand for the Avensis’ tidy, no-fuss character.

Popular questions about the 2006 Toyota Avensis exhaust mount

How many exhaust mounts does a 2006 Avensis have?
Most T25 Avensis variants use three to five rubber mounts, depending on engine, body style, and exact exhaust layout. Expect at least one at the front/centre section and multiple at the rear muffler to keep the system aligned and isolated.

What are the signs an Avensis exhaust mount needs replacing?
Common clues include a tailpipe sitting off-centre, metallic knocks over bumps, droning or extra vibration in the cabin, and visibly cracked or stretched rubber hangers. If the exhaust can be pushed around easily by hand, the mounts are likely tired.

Can universal rubber hangers be used?
Universal hangers can work in a pinch, but OE-spec dimensions and rubber hardness help keep clearances right and prevent new vibrations. If using universal parts, match the hole spacing and thickness closely to the Avensis’ original mounts.