Parts for your 2006 Suzuki Swift-Exhaust mount

2006 Suzuki Swift exhaust mount: what it does and when to replace it

Yes, the 2006 Suzuki Swift uses exhaust mounts. This is confirmed by the Suzuki Swift workshop/service manual for the RS413/RS415/RS416 series, which shows “silencer mounting rubber” and exhaust brackets supporting the front pipe, centre muffler and rear muffler, and by Suzuki EPC/parts catalogues and common aftermarket parts lists that specify multiple rubber exhaust hanger mounts for this model.

The exhaust mount on a 2006 Swift is a tough rubber hanger that suspends the exhaust system from the body. Its job is to keep the pipes and mufflers aligned while soaking up vibration and movement as the engine rocks and the car travels over rough roads. Good mounts prevent annoying rattles, protect welds and flanges from stress, and stop the tailpipe from knocking the underbody or rear beam when the car hits bumps or twists through corners.

On a Swift that’s a few years into Aussie or Kiwi conditions—especially near the coast—these rubber mounts can harden, crack, or stretch. That’s when the tailpipe might sit low or swing, the exhaust can tap on heat shields, and you may hear a dull thud over speed humps or a buzzy drone at certain revs.

As part of regular servicing, it’s smart to inspect the exhaust mounts every 10,000–15,000 km or annually:

• Look for perished, cracked, or elongated rubber and rusty brackets.
• Check exhaust height and clearance around the rear beam, bumper and heat shields.
• Lightly lever the muffler—excessive movement means the mounts are tired.

Replacement is straightforward with the car safely supported. A spritz of silicone spray helps slide the old rubbers off the pegs. Swap like-for-like quality rubber hangers and inspect the metal hangers and brackets for bends or corrosion while you’re there. Refit with the muffler sitting neutral—not preloaded to one side—and tighten any brackets to the torque specified in the workshop manual. If one mount has failed, consider replacing the set so the system sits even and stays quiet.

Ignoring worn mounts can crack welds, stress the flex joint, and create leaks that sound rough and cost more to sort. Fresh mounts are cheap insurance for a calm cabin and a tidy-looking rear end on a 2006 Suzuki Swift.

Popular questions

How many exhaust mounts does a 2006 Suzuki Swift have?
Most 2006 Swifts run multiple rubber mounts: typically one near the centre section and two around the rear muffler, plus brackets that tie the lot to the body. Exact count can vary with trim and market. A quick look under the back end usually reveals them near the muffler can and mid-pipe.

How often should the exhaust mounts be replaced?
There’s no fixed interval—replace on condition. Inspect at each service. In hot or coastal climates, rubber can age faster, so many owners end up changing them somewhere between 80,000–150,000 km, or sooner if there’s sagging, noise, or visible cracking.

Can a home mechanic replace the mounts on a Swift?
Yes, if they’re comfortable working safely under the car. Use axle stands on solid ground, silicone spray, and gloves. Stubborn mounts may need dedicated hanger pliers. If the exhaust needs realignment or a bracket is bent or rusty, it’s worth getting a workshop to sort it properly.