Parts for your 2006 Mitsubishi Pajero-Tail lights

2006 Mitsubishi Pajero tail-lights — what they do and how to look after them

Tail-lights are absolutely fitted to the 2006 Mitsubishi Pajero. Mitsubishi’s 2006 Pajero Owner’s Manual and Workshop Manual (Group 54A – Lighting) specify the rear combination lamp assembly, bulb types and fuses. Australian Design Rules (ADR 13/00 and ADR 49/00) and the equivalent UNECE Regulation No. 7 also mandate rear position lamps on road-going vehicles. So, on this Pajero, tail-lights aren’t optional — they’re essential and standard equipment.

On the 2006 Pajero, the rear combination lamps house the tail (rear position) lights along with brake, indicator, reverse and, on some trims, rear fog. The tail-lights run whenever the park/headlamps are on, marking the vehicle’s width and presence at night or in foul weather. They’re a big part of staying legal and being seen on outback highways, coastal roads and city commutes alike.

For routine servicing, it’s smart to check them at each fuel stop or at least monthly. Look for even brightness left to right, no cracks in the lenses and no moisture inside the housings. Most 2006 Pajeros use common globe types — often a P21/5W dual‑filament for stop/tail in a single bulb, or a W5W/W21W for tail with a separate P21W for stop, depending on trim. Always confirm the exact spec in the owner’s manual or on the lamp body.

• If a tail-light is out, check the “TAIL”/“PARK” circuit fuse (often 10 A) in the interior fuse box, and inspect the globe and socket for heat damage or corrosion.
• Trailer plugs and aftermarket tow modules are frequent culprits for intermittent faults — unplug and retest if the fuse keeps popping.
• The tailgate wiring loom on some Pajeros can fatigue near the hinge, look for broken or brittle wires if lights work on-and-off.

Replacing a globe or the whole assembly is straightforward: open the tailgate, remove the two screws at the lamp’s inner edge, then pull the cluster straight back to release the clips. Twist out the bulb holders, swap the globe (avoid touching the glass), and refit carefully so the gasket seals against dust and water. Don’t overtighten the screws into the plastic. If upgrading to LEDs, choose ADR-compliant lamps and CANBUS-friendly bulbs, indicators may need resistors to avoid hyperflash. After any work, test park, brake and indicator functions before heading off.

Popular questions about 2006 Mitsubishi Pajero tail-lights

What bulb type does a 2006 Pajero use for its tail-lights?
Most 2006 Pajeros run either a P21/5W dual‑filament globe for stop/tail in one bulb, or a separate W5W/W21W for tail with a P21W for the brake. Variations exist by trim and build date, so checking the owner’s manual or the markings on the lamp/holder is the safest bet. If choosing LEDs, pick ADR-compliant, CANBUS-friendly options.

Why does the tail-light fuse keep blowing on my Pajero?
Common causes include a shorted globe, corroded socket, pinched wiring in the tailgate loom, or an issue with a trailer harness/tow module. Start by removing the trailer plug, inspecting the bulb and holder, then checking the loom where it bends at the tailgate hinge. Replace the correct “TAIL”/“PARK” fuse rating only after fixing the fault.

How do I remove the tail-light assembly on a 2006 Pajero?
Open the tailgate, undo the two Phillips screws on the inner edge of the lamp, then pull the cluster straight rearwards to release the clips. Disconnect the wiring plug, twist out the bulb holders, and service or replace as needed. When refitting, seat the gasket properly and press the clips in line to avoid cracking the housing.