Parts for your 2006 Mitsubishi Lancer-Wiper refills

2006 Mitsubishi Lancer wiper refills — purpose, fitment and easy upkeep

For the 2006 Mitsubishi Lancer (CG/CH series in AU/NZ), wiper refills are absolutely relevant. Mitsubishi’s service info and common parts catalogues list the wiper rubber insert as a normal service item, and the factory-style framed blades on these cars are designed to accept slide-in refills. That means owners can refresh the rubber without binning the whole blade assembly, saving a few dollars and reducing waste.

The job of a wiper refill is simple but critical: keep the windscreen clear of rain, spray, and road grime so visibility stays sharp. A fresh, correctly sized refill hugs the glass evenly, wipes quietly, and leaves no streaks. On a Lancer that’s used daily, especially in Aussie and Kiwi conditions with strong UV and sea air, the rubber naturally hardens over time.

As part of routine servicing, it’s smart to inspect the Lancer’s wiper refills every service and replace them every 6–12 months, or sooner if performance drops. Tell-tale signs they’re due include:

• Streaking, hazy patches, or missed arcs
• Chatter or squeaks across the windscreen
• Cracks, nicks, or a flattened wiping edge

Replacement is a quick, no-fuss task on most 2006 Lancers with OE-style frames. Match the refill profile and length to the blade (many refills can be trimmed to fit), slide the old insert out with its metal rails, then feed the new insert in until it locks at the end cap. If the blade frame is bent, corroded, or you’ve switched to a beam/aero blade that doesn’t take inserts, go for a complete blade replacement instead.

Handy maintenance tips to stretch refill life:

• Clean the windscreen and the rubber with mild soapy water regularly.
• Avoid silicone or petroleum-based sprays on the rubber — they can swell or smear.
• Keep the arm off the glass during changes and don’t let it snap back onto the windscreen.
• If your Lancer has a rear wiper (some body styles), note it may use a different refill or a one-piece rear blade.

Quality refills — often graphite-coated natural rubber — deliver quiet, consistent wiping. Paired with a clean screen, they keep the 2006 Lancer ready for sudden downpours and early-morning mist without any dramas.

Popular questions about 2006 Mitsubishi Lancer wiper refills

What sizes fit a 2006 Mitsubishi Lancer?
Most 2006 Lancer sedans in AU/NZ commonly use a longer driver’s side and a shorter passenger blade, often around 22 inch and 19 inch respectively. Because blade frames and body styles can vary, it’s best to measure the existing blades or check the owner’s manual/parts guide. Many refill kits are cut-to-length, so you can trim for a perfect fit.

Can they replace just the rubber, or do they need full blades?
On OE-style framed blades fitted to many 2006 Lancers, the rubber insert is designed to be replaced on its own. If the frame is twisted, rusty, or you’ve upgraded to beam-style blades that don’t accept inserts, swap the complete blade assembly instead. Functionally both approaches restore wiping — refills are simply the more economical and lower-waste option when compatible.

How often should wiper refills be changed?
Plan on every 6–12 months, with inspections at each service. High UV, coastal air, and frequent use can shorten that window. If you notice streaks, chatter, or cracks, replace them straight away for safe, clear vision in the wet.