Parts for your 2006 Mitsubishi Lancer-Brake hose

2006 Mitsubishi Lancer Brake Hose — Purpose, Care and Replacement

Yes, a brake hose is fitted to the 2006 Mitsubishi Lancer. Technical sources including the Mitsubishi Lancer 2002–2007 Service Manual (Group 35A – Brakes), the Mitsubishi ASA Electronic Parts Catalogue, and the Haynes Repair Manual for Mitsubishi Lancer 2002–2010 specify flexible hydraulic brake hoses in the front circuit and at the rear (centre hose to the rear axle on drum‑rear models, with additional rear caliper hoses on disc‑rear variants).

On this Lancer, the brake hose is the flexible link that lets the suspension and steering move while keeping hydraulic pressure flowing to the brakes. The fronts each have a hose to the caliper, at the rear there’s typically a central hose from body to axle on drum setups, and rear disc models add a hose at each caliper. These hoses cop heat, road grime, UV and constant flexing, so condition matters for safe, consistent braking.

As part of routine servicing, the brake hoses should be visually checked at every service and replaced if there are cracks, bulges, leaks, abrasion, or if the pedal feel has gone spongy. Even when they look fine, internal lining can degrade and collapse with age, so many techs recommend replacement every 6–10 years, or sooner if there’s any doubt. Brake fluid should be flushed about every two years, always use the spec shown on the master cylinder cap (commonly DOT 3 or DOT 4) and keep fluid off paintwork.

When replacing, do both sides on the same axle to keep braking response even. Use proper flare spanners to avoid rounding fittings, and don’t twist the new hose—fit it so the suspension can cycle lock‑to‑lock without tension. Renew copper/aluminium sealing washers where fitted, clip the hose into all retainers, and check that nothing rubs on the tyre or strut. After installation, bleed the system thoroughly (including ABS procedure where applicable) and road‑test for a firm, straight stop.

• Watch for: surface cracking, wetness from leaks, soft pedal, brake pull, or a caliper not releasing (a sign of internal hose collapse).
• Fit ADR‑compliant or quality OEM‑equivalent hoses and new clips.
• If the steel line flare or bracket is corroded, address it at the same time.

Looked after properly, the Lancer’s brake hoses keep pedal feel crisp and braking predictable—exactly what’s wanted on Aussie and Kiwi roads.

Popular questions about 2006 Mitsubishi Lancer brake hoses

How many brake hoses does a 2006 Lancer have?
Most have two front hoses and one rear centre hose for drum‑rear models. Variants with rear disc brakes typically add a hose at each rear caliper. Build spec can vary, so checking the VIN against the parts catalogue is best.

What brake fluid should be used after hose replacement?
Use the fluid grade printed on the master cylinder cap—typically DOT 3 or DOT 4 for this era Lancer. Fresh, unopened fluid is essential, and a full bleed is recommended after any hose change.

Do hoses need changing even if they look OK?
They can deteriorate internally without obvious outside damage. If the vehicle is over a decade old, or there are symptoms like a soft pedal or dragging brakes, replacement is smart preventative maintenance.