Parts for your 2006 Honda Fit-Pedal pads

2006 Honda Fit (Jazz) Pedal Pads — Purpose, Wear and Service Tips

Technical sources confirm pedal pads are fitted to the 2006 Honda Fit (known as Jazz in Australia and New Zealand). The Honda Electronic Parts Catalogue (GD1/GD3) and the Honda Jazz/Fit GD Service Manual list removable rubber pads for the brake pedal, and for the clutch pedal on manual models. The accelerator is typically a moulded pedal without a separate rubber pad. Local standards such as the NZTA WoF Inspection Manual and Australian roadworthy guidelines also call out non-slip pedal surfaces, underlining that pedal pads are a safety item on this vehicle.

On this model, pedal pads provide a grippy, non-slip surface so the driver’s shoe stays planted under wet boots, sandy thongs, or muddy work shoes. The rubber pad also helps dampen vibration and protects the metal pedal face from wear. Over time, the pad hardens and polishes smooth, or cracks and thins—especially on high-kilometre city cars.

During routine servicing, it’s smart to inspect the pads. If the rubber is glossy, has chunks missing, or the underlying metal is visible, replacement is due. Brake (and clutch, if fitted) pads press on and off by hand in a few minutes, no special tools needed—just clean the pedal face and seat the new pad evenly so the lip locks around the edges.

• Common signs it’s time to replace:
  • Slippery feel, especially in the wet
  • Cracks, splits, or hardened rubber
  • Edges lifting or pad not sitting square
  • Metal of the pedal showing through
• Quick care tips:
  • Wipe with mild soap and water, avoid silicone dressings that make pads slick
  • Check during each service or every 20,000 km
  • Replace in pairs on manual cars (brake and clutch) to keep feel consistent

Genuine or quality aftermarket pads designed for the GD-series Fit/Jazz will fit snugly and restore proper grip. On automatic versions, only the brake pedal typically has a rubber pad—so that’s the one to watch. A fresh pad costs little, takes minutes to fit, and can make a big difference in pedal feel and roadworthiness.

Popular questions about 2006 Honda Fit pedal pads

How often should pedal pads be replaced on a 2006 Honda Fit?
There’s no strict interval. Most owners replace them when they feel slippery or show cracks, which commonly happens anywhere from 60,000 to 150,000 km depending on driving conditions. During regular services, a quick visual and touch check is enough to decide.

Does the accelerator have a pedal pad on this model?
On most 2006 Fit/Jazz trims the accelerator is a single moulded pedal without a separate rubber pad. The brake (and clutch on manuals) use removable rubber pads. If the accelerator’s surface is worn smooth or damaged, the whole pedal assembly is typically replaced rather than a pad.

Will worn pedal pads fail a WoF or roadworthy inspection?
They can. Inspectors look for secure, non-slip pedal surfaces. If the brake or clutch pad is missing, loose, or excessively smooth, it may be flagged. A new pad is inexpensive and usually restores compliance and safe grip.