Parts for your 2006 Honda Elysion-Gas struts

2006 Honda Elysion gas struts — what they do and when to replace

Based on technical references, the 2006 Honda Elysion does use gas-filled struts on the rear tailgate, but not on the bonnet. The Honda Elysion Owner’s Manual (JDM, 2004–2006) specifies a support rod for the bonnet rather than a damper, while the Honda Electronic Parts Catalogue (RR1–RR4) lists a tailgate “stay”/gas spring with ball-stud fittings. Honda service literature for the Elysion also includes procedures for tailgate lift support replacement. That makes gas struts directly relevant to the rear tailgate only.

On the Elysion, the tailgate gas struts counterbalance the weight of the hatch, making it easy to lift and keeping it safely open while loading gear or wrangling kids. When they’re healthy, the tailgate glides up smoothly and holds its height. When they’re tired, they struggle in colder weather, need a helping hand to rise, or let the tailgate sag.

Typical signs it’s time to swap them out include:

• Tailgate drops or won’t stay up on its own
• Slow, jerky opening or a need to “help” it up
• Oily film on the strut shaft or squeaking from the ball sockets
• Noticeably worse performance on cold mornings

Replacement isn’t mileage-based, most owners see 5–10 years out of a set depending on climate and use. Best practice is to replace both sides together to keep lift and balance even. On Elysions with a power tailgate option, use the correct force-rated struts for that system and follow any relearn/calibration steps noted in service information.

For a tidy DIY, support the tailgate with a prop or a helper, then pop off the retaining clips at each end and swap one strut at a time. Don’t clamp the shiny shaft with pliers and don’t grease it—just wipe it clean with a lint-free cloth. A dab of silicone-safe lubricant on the ball joints (not the shaft) can quiet any creaks. While you’re there, check the ball studs and brackets for play or corrosion and replace any that look tired.

Choosing quality aftermarket or genuine parts with the correct length and Newton rating keeps the tailgate feeling factory-fresh and avoids overloading hinges or power actuators. Dispose of old struts responsibly—they’re pressurised components.

FAQs

Does the 2006 Honda Elysion have gas struts on the bonnet?
No. The bonnet uses a manual prop rod. Gas struts are fitted to the rear tailgate. This setup is consistent with the Honda Elysion Owner’s Manual and the parts catalogue for RR1–RR4 models.

How long do tailgate gas struts last on an Elysion?
There’s no set interval, but many last 5–10 years. Replace them when the hatch won’t hold itself up, rises slowly, or shows oil on the shaft—especially if it’s worse in cold weather.

Can just one tailgate strut be replaced?
It’s not recommended. Replacing in pairs keeps lift balanced and prevents the good strut from overworking. If the vehicle has a power tailgate, always use the correct force rating and follow any calibration notes.