Parts for your 2005 Mitsubishi Lancer-Pedal pads

2005 Mitsubishi Lancer Pedal Pads — What They Do and When to Replace

Pedal pads are absolutely relevant to the 2005 Mitsubishi Lancer (CS/CH series). The Mitsubishi Lancer 2002–2007 Service Manual and the Mitsubishi ASA electronic parts catalogue both list rubber pedal pads for the brake pedal on all models, with an additional rubber pad on the clutch pedal for manual-transmission cars. The accelerator is typically a moulded plastic pedal without a separate rubber pad. Haynes/Gregory’s repair manuals covering these years also note pedal pad inspection and replacement as routine service items.

On a 2005 Lancer, pedal pads serve a simple but critical job: they provide grippy, compliant surfaces so a driver’s shoe doesn’t slip off the pedals, especially in the wet. They reduce vibration, improve comfort on longer trips, and help meet roadworthy/fitness requirements that call for pedals to be non-slip and in good condition.

As part of regular servicing, it’s smart to inspect the pads every 10,000–15,000 kilometres (or at each service). Rubber hardens and wears over time. If the pad has gone shiny, smooth, cracked, or is starting to peel away from the metal pedal, it’s time to swap it out. For manual cars, check both brake and clutch, on autos, focus on the brake. A clean, grippy surface is a safety win and can prevent a WOF/roadworthy knock-back.

• Signs it’s due: glazed or slippery feel, visible tears, missing chunks, edges lifting, or metal pedal face showing through.
• Good practice: avoid silicone dressings on pads, they can make them slippery. Clean with mild detergent and dry thoroughly.

Replacement is a quick DIY: pull the old rubber off (start at a corner), clean the pedal face, then warm the new pad slightly and work it on from one edge until the lip seats evenly all around. After refitting the brake pad, give the pedal a few presses to confirm a solid feel and ensure the brake-light switch isn’t affected. On manuals, do the same for the clutch.

• Parts choice: OEM-style rubber pads fit best and last well, many aftermarket options are fine but match your transmission type.
• Note: Accelerator pedals on this model don’t usually use a separate rubber pad, if you want extra grip, use model-specific covers only.

FAQs

Does a 2005 Mitsubishi Lancer have a pedal pad on the accelerator?
On CH/CS Lancers, the accelerator is typically a moulded plastic pedal without a removable rubber pad. The brake pedal always has a rubber pad, and manuals add a clutch pad. Aftermarket covers exist, but stick with parts designed for the Lancer to avoid interference.

How often should pedal pads be replaced on a 2005 Lancer?
There’s no fixed interval—replace when worn. Inspect at each service. If the pad is shiny, cracked, hardened, or slipping on the pedal, fit a new one. Many drivers see 3–7 years depending on use, footwear, and climate.

Are brake and clutch pedal pads the same between auto and manual Lancers?
The brake pad is typically common across auto and manual of the same generation, but the clutch pad is unique to manual models. Always confirm by VIN in the Mitsubishi EPC or with a dealer to ensure the right fit.