Parts for your 2004 Honda Stream-Pedal pads

2004 Honda Stream pedal pads — purpose, care and replacement

Based on technical references — the Honda Stream (RN1–RN5) Service Manual sections covering brake/clutch controls, and the Honda Electronic Parts Catalogue (EPC) listings for “Pedal, Brake/Clutch” and “Pad, Pedal” — pedal pads are used on the 2004 Honda Stream. The brake pedal has a rubber pedal pad on all models, the clutch pedal (manual variants) also uses a rubber pad, while the accelerator is an integral pedal face without a separate replaceable pad.

On a 2004 Honda Stream, those rubber pedal pads matter more than they look. They provide grippy, consistent pedal feel in wet boots, reduce vibration through the sole, and help the car meet basic roadworthy/WOF expectations across Australia and New Zealand. When they wear smooth, crack, or go hard and shiny, foot slip risks go up and inspectors often call them out at rego or Warrant of Fitness time.

As part of routine servicing, pedal pads should be visually checked every service or 10,000–15,000 km. Tell‑tales include smooth slick spots, edge tears, pads that don’t sit flat on the metal pedal plate, or any slipping underfoot. Automatic Streams use only the brake pad, manuals should have both brake and clutch pads inspected together. Technical sources (Honda EPC and service manual) note the accelerator is an assembly item, so there’s no separate “accelerator pedal pad” to replace.

Replacement is quick and inexpensive, and genuine or quality aftermarket rubber is recommended to keep the correct thickness and tread pattern.

1. Park safely, ignition off. Pull the old pad off the metal pedal plate.
2. Clean the pedal plate with a mild degreaser, dry thoroughly.
3. Warm the new pad slightly (sunlight or warm water) for flexibility.
4. Hook the top lip first, then work the pad evenly around the perimeter until fully seated.

No adhesive is needed, a proper pad fits snugly. Avoid silicone dressings on pads — they can make the surface slippery. A light wash with mild soap and water keeps the rubber grippy. After fitting, press the pedal a few times to confirm the pad stays put, and ensure floor mats can’t slide up and interfere with pedal travel.

Referencing the Honda Stream RN1–RN5 Service Manual and Honda EPC ensures the right part is chosen for auto vs manual models and confirms the accelerator pedal is not a separate pad item on this vehicle.

Popular questions about 2004 Honda Stream pedal pads

Do all 2004 Honda Streams have the same pedal pads?
Automatic models have a brake pedal pad only, while manual models have both brake and clutch pedal pads. The accelerator pedal face is part of the pedal assembly and isn’t a standalone rubber pad. Checking the Honda EPC by VIN is the best way to confirm the correct pad style for a given vehicle.

Will worn pedal pads fail a WOF or roadworthy?
Often, yes. If the pad is smooth, cracked or missing, inspectors can flag it as a safety issue due to reduced grip. Replacing worn pads is inexpensive, takes minutes, and helps keep the Stream compliant and safer underfoot.

How long do pedal pads typically last?
Usage and climate drive lifespan, but many last 5–10 years. Frequent city driving, muddy worksites, or harsh cleaners can shorten life. A quick check at each service is the easiest way to decide when to swap them out.