Parts for your 2004 Honda Elysion-Oil filter

2004 Honda Elysion Oil Filter — What It Does and When to Change It

Yes, the 2004 Honda Elysion uses an engine oil filter. Technical references including the Honda Elysion factory service information for the J30A/J35A V6 and the Honda Electronic Parts Catalogue list a screw-on engine oil filter for this model. Typical Honda genuine part numbers referenced for J-series engines include the 15400-PLM-A01/A02 family, confirming the filter is a standard service item on the 2004 Elysion.

On this V6 people mover, the oil filter’s job is straightforward but critical: it traps fine metal particles, carbon, and grit so the lubricant can keep bearings, cam lobes, and lifters happy. Clean oil helps the Elysion’s i-VTEC V6 run quietly and efficiently, reduces wear at cold start, and supports stable oil pressure on long motorway hauls or when lugging the family and gear.

For day-to-day ownership in Australia or New Zealand, it’s smart to replace the oil filter at every oil change. Most owners stick to about every 10,000 km or 12 months, whichever comes first. If the Elysion does lots of short trips, towing, or sees dusty roads, consider tightening that to 5,000–7,500 km. Honda’s service literature also notes to change the filter any time the oil is changed under severe driving conditions.

Handy servicing pointers for the Elysion’s filter:

• Access: The spin-on filter sits low at the front of the engine, a drip tray and gloves make life easier.
• Prep: Lightly oil the new filter’s gasket, spin it on until the seal contacts, then tighten about 3/4 turn by hand. Don’t overdo it.
• Check: Make sure the old rubber gasket hasn’t stuck to the housing. A “double gasket” will leak.
• Top-up and test: Refill engine oil to spec, start the engine, and check for leaks and stable oil pressure. Recheck the level after a short drive.

Quality-wise, a genuine Honda filter (as catalogued for J30A/J35A) or a reputable equivalent that meets OEM specifications is the safe bet. It’ll hold the right bypass pressure and filtration efficiency for this engine. Keeping the filter fresh is cheap insurance that helps the Elysion stay smooth, economical, and ready for the next road trip.

Popular questions about 2004 Honda Elysion oil filters

What oil filter fits a 2004 Honda Elysion?
Honda’s own parts listings for the J30A/J35A V6 show a spin-on filter from the 15400-PLM-A01/A02 family or superseding genuine numbers that meet the same spec. Many quality aftermarket brands cross-reference to these OEM numbers for the Elysion.

How often should the oil filter be changed?
As a rule of thumb, change the filter with every oil change—about every 10,000 km or 12 months. If the vehicle does frequent short trips, towing, or drives in dusty conditions, shorten the interval to 5,000–7,500 km to keep the oil system in top nick.

Where is the oil filter located on the Elysion V6?
It’s mounted low on the front of the engine. From underneath, it’s easy to spot and remove with a cup or band wrench. Always use a drain tray and watch for hot oil if the engine’s been running.