Your Selected Vehicle
Parts for your 2004 Daihatsu Yrv-Headlights
Explore 4WD & Adventure
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps 12/24V LED Amber Emergency Light Flash Patterns With Sync Wire Blister Pack - 120035AM
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Licence Plate Lamp Blister Pack Containing Left & Right Lamps - 99ARL2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12/24V Amber Emergency Mini Light Bar Clear Lens With Amber LEDs 18 Selectable Flash Patterns - LB380ACM
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
LED Autolamps 10/30V Front Outline Position Marker With 2 White LED Blister Pack - 58WM
2004 Daihatsu YRV headlights
Headlights are absolutely fitted and relevant on the 2004 Daihatsu YRV. Technical references including the 2004 Daihatsu YRV owner’s and workshop manuals, plus regulatory standards like Australian Design Rule (ADR) 13/00 for lighting installation and the New Zealand Land Transport Rule: Vehicle Lighting 2004, confirm that the YRV is factory-equipped with halogen headlamps for legal night-time and low-visibility driving.
On this compact, practical runabout, the headlights do the heavy lifting after dark and in foul weather, throwing a clean beam to help spot hazards while keeping glare down for oncoming traffic. Most 2004 YRV variants run a dual‑filament halogen bulb (commonly H4 60/55W) for low and high beam in one unit, though owners should always check the handbook or the lamp cap for the exact spec. As it’s a right‑hand‑drive market car, the beam pattern suits Australia and New Zealand roads and needs to meet local roadworthy and WoF checks.
As part of routine servicing, it’s smart to:
- Inspect operation of low and high beam, parkers and indicators monthly.
- Clean the lenses with a pH‑neutral wash, avoid harsh solvents that can craze plastic.
- Check aim against a flat wall and adjust to spec to avoid dazzling others.
- Replace bulbs in pairs to keep colour and brightness even.
- Look for lens clouding or yellowing, consider UV‑safe restoration if needed.
- Confirm the rubber dust boots are seated, and connectors are snug and corrosion‑free.
When swapping a bulb, switch the lights off, disconnect the battery if preferred, pop off the dust boot, release the spring clip, and ease the bulb out. Don’t touch the new bulb’s glass with bare fingers—skin oils can shorten its life—use gloves or a clean tissue. Refit the bulb with the locating tab aligned, lock the clip, reseat the boot, reconnect the plug, and test both beams. A quick re‑aim check afterwards is worth the extra minute.
If a headlamp is intermittently cutting out, don’t just blame the bulb. Check the fuse, the earth point near the lamp, and the switchgear. A light smear of dielectric grease on the connector can help keep moisture out. Keep things up to scratch and the YRV’s headlights will pass roadworthy/WoF inspections and keep night driving comfortable.
What headlight bulb does a 2004 Daihatsu YRV use?
Most 2004 YRV models use an H4 60/55W halogen dual‑filament bulb that handles both low and high beam in one. Always confirm by checking the owner’s manual or the marking on the bulb cap, as trim levels and markets can vary.
How can the headlight aim be adjusted on a 2004 YRV?
Park on level ground facing a flat wall, about three to five metres back. Mark the centre height of the lamps on the wall, switch to low beam and use the adjusters on the rear of each headlamp to set the cutoff pattern just below the marked height and centred ahead of the vehicle. Follow the workshop spec if available.
Why are the YRV’s headlight lenses cloudy?
UV exposure and road grime can oxidise the plastic over time, causing haze and reduced light output. A proper headlight restoration kit with wet‑sand, polish and a UV sealant usually brings them back. If the lens or reflector is damaged or the seal has failed, a replacement assembly may be the better fix.