Your Selected Vehicle
Parts for your 2003 Mitsubishi Pajero-Headlight bulbs
Explore 4WD & Adventure
LED Autolamps 12/24V LED Number Plate Light LED With 0.14M Lead (2 pce) - 30BLM
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflector 100x100x22mm - 101BAR
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Amber Red LED Light - 282ARWM
LED Autolamps 10/30V Rear Position Marker 2 Red LEDs With 40cm Wire Blister Pack - 58RM
LED Autolamps 12/24V LED Stop/Tail Lamp With Red Lens Round With Grommet/Plug - 113RMG
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reverse Lamp 200x50x28mm Twin Blister - 200BIRSTME2
LED Autolamps 12V LED Boat Trailer Lamps Stop/Tail/Indicator with Licence Plate Lamp Light Left & Right Side, with 8m cable, Twin Blister - 209GARLP2/8M
2003 Mitsubishi Pajero headlight bulbs
Based on technical references such as the 2003 Mitsubishi Pajero owner’s manual (NM/NP series), Mitsubishi ASA parts catalogues, and major bulb-fitment guides from Osram and Philips, this model is fitted with replaceable halogen headlight bulbs. Many 2003 Pajero variants use an H4 dual‑filament globe for combined low/high beam, while some trims use separate bulbs (commonly HB3/9005 for high beam and H1 or H7 for low beam). Checking the owner’s manual or the sticker behind the headlamp cover under the bonnet will confirm the exact fitment.
The headlight bulbs do the heavy lifting after dark—helping the driver see the road ahead and making the Pajero visible to others. They’re also key to passing WOF/CoF or roadworthy checks across Australia and New Zealand. As halogen bulbs age, light output drops and the colour shifts, so even before a globe fails, visibility can suffer. Replacing bulbs in pairs keeps beam colour and brightness matched side to side.
Good servicing practice is to inspect the Pajero’s headlight operation at each service interval and before long trips. Look for dim, flickering, or yellowed light, haze in the lens, moisture inside the housing, heat damage on connectors, and brittle rubber caps. If upgrading bulb performance, stick with ADR-compliant options and ensure beam aim is checked afterwards.
- Confirm bulb type: Check the manual or existing bulb markings (e.g., H4, HB3, H1, H7).
- Power off: Switch ignition and lights off, disconnect the battery if desired.
- Access the rear cover: Remove the rubber cap or plastic lid behind the headlamp.
- Release the clip or twist-lock: Note the bulb orientation.
- Install the new bulb: Avoid touching the glass, use gloves. Seat it fully and secure the clip.
- Reconnect and test: Verify low and high beam, then adjust aim if needed.
- Replace in pairs to keep brightness even.
- Clean the lens exterior, cloudy lenses cut output dramatically.
- Use dielectric grease on connectors if they’re exposed to moisture.
- If fuses blow or bulbs fail early, have charging voltage and earths checked.
FAQs
What bulb type fits a 2003 Mitsubishi Pajero?
Most 2003 Pajero variants use an H4 dual‑filament globe. Some trims run separate high/low beams, typically HB3 (9005) for high and H1 or H7 for low. Always verify against the owner’s manual, the label behind the headlamp cover, or a reputable bulb catalogue for the exact variant.
How often should the headlight bulbs be replaced?
Halogen bulbs gradually dim, so many owners replace them every 3–5 years or at the first sign of reduced brightness, yellowing, or flicker. Replace in pairs and recheck headlight aim after fitting.
Can the Pajero’s halogen bulbs be upgraded to LED?
Retrofit LEDs may not be legal in halogen reflector housings unless the headlamp assembly is certified to the relevant ADR/NZTA standards. If considering LEDs, confirm compliance, beam pattern, and aim. For a simpler, legal boost, choose premium halogen upgrades that meet ADR requirements.