Parts for your 2003 Honda Cr-v-Pedal pads

2003 Honda CR‑V pedal pads: what they do and when to replace them

Pedal pads are fitted to the 2003 Honda CR‑V. The Honda Electronic Parts Catalogue for this model year lists a rubber brake pedal pad for all variants, and a clutch pedal pad on manual-transmission models. The factory Honda CR‑V 2002–2004 Service Manual (Brakes – Brake Pedal) also calls out inspection of the pedal pad for wear and secure fit. The accelerator on this generation is a moulded pedal and typically isn’t serviced as a separate “pad”.

On this CR‑V, the pedal pads are the grippy rubber covers that sit over the metal brake (and clutch, if manual) pedal. Their job is simple but critical: provide a non‑slip surface so boots don’t slide off in the wet, mud or dust — pretty common conditions across Australia and New Zealand. When the ribs wear smooth, crack, or the pad loosens, braking and clutch control can be compromised.

As part of regular servicing, it’s smart to check pedal pads every 10,000–15,000 km or at each service interval. Many roadworthy/WOF inspections expect the brake pedal to have a secure, anti‑slip surface, so replacing a tired pad avoids a fail and keeps the cabin safe.

• Signs it’s time: shiny or smooth surface, visible cracks, hardened rubber, pad edge lifting off the pedal, or the pad missing entirely.
• Cleaning tip: wash with mild soapy water and a soft brush. Avoid silicone dressings — they can make pedals slippery.
• Replacement: the pad usually pulls off by hand, warm the new pad slightly to make it more pliable, then hook the lip over the pedal plate and work it around evenly until fully seated.

For a manual CR‑V, treat the clutch pedal pad the same way. On automatics, you’ll only be dealing with the brake pedal pad. Genuine Honda pads are inexpensive and fit perfectly, but quality aftermarket pads to OEM spec are fine if they list compatibility with the 2003 CR‑V. Always confirm the transmission type when ordering, and ensure floor mats are clipped down and clear of the pedals after refitting.

Technical references: Honda Electronic Parts Catalogue for 2003 CR‑V (lists brake and clutch pedal rubber pads by application), Honda CR‑V 2002–2004 Service Manual, Brakes – Brake Pedal (inspection for pad wear/fit).

Popular questions

How can an owner tell if the 2003 CR‑V’s brake pedal pad is worn out?
If the ribs feel smooth or slippery underfoot, the rubber is cracked or hard, or the pad doesn’t sit tight on the metal pedal, it’s due. Any missing chunks or exposed metal means replace it immediately.

Does the 2003 CR‑V accelerator have a replaceable pad?
No. The accelerator is a one‑piece pedal, it isn’t serviced as a separate rubber pad. Only the brake (and clutch on manuals) use removable rubber pads.

What tools are needed to change a pedal pad, and how long does it take?
Usually none — just hands and a clean rag. Warming the new pad slightly helps it stretch on. It’s a 5‑ to 10‑minute job, perfect to do during a routine service.