Your Selected Vehicle
Parts for your 2002 Toyota Avensis-Tail lights
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
Explore 4WD & Adventure
LED Autolamps 12/24V LED Stop/Tail/Indicator Lamp With Reflex Reflector Blister Pack 1 pce - 150ARM
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reverse Lamp 200x50x28mm Twin Blister - 200BIRSTME2
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Diffused Tail Function With Sequential Indicator - 520ARWM-2
LED Autolamps 12V/24V Maxilamp 5 Lamp Combination Stop/Tail/Indicator/Reverse/Reflector - MAXILAMPC5XRW
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
2002 Toyota Avensis Tail-Lights
Tail-lights are absolutely fitted to the 2002 Toyota Avensis and are required by road regulations. Technical sources that confirm this include the Toyota Avensis (T22) Owner’s Manual lighting section, the Toyota Electronic Parts Catalogue listing the rear combination lamp assemblies, and UNECE Regulation No. 48/ADR lighting installation rules, which mandate rear position lamps (tail-lights) on passenger vehicles. So yes—this Avensis uses tail-lights, and they’re essential for safety and compliance.
On a 2002 Avensis—whether sedan, liftback, or wagon—the tail-lights sit within a rear combination cluster alongside the brake, indicator, reverse, and often rear fog lights. Their main job is to make the car visible from behind in low light, rain, and at night, helping other drivers judge distance and width. If they’re dull, cracked, or out, visibility drops and it can risk a failed WOF/reg or a fine.
Owners keen on easy upkeep can give the lights a quick check every month: switch on the park lights and walk around the car (or use a wall/garage door reflection). Look for dim glows, cracked lenses, or condensation inside the housing. Moisture points to tired seals or a hairline crack—left alone, it can corrode bulb holders and connectors.
Replacing a globe is straightforward. Open the boot, peel back the trim, undo the retaining nuts or clips for the lamp, unplug the connector, then twist out the bulb holder. Swap the globe—avoid touching the glass with bare fingers—and refit in reverse. Body style can change access slightly, but tools are basic: Phillips screwdriver, small socket, and trim tool. Check the Owner’s Manual for the exact globe types