Skip to content Skip to navigation menu

Your Selected Vehicle

Brands

Show More Show Less

Price

Parts for your 2002 Nissan Navara-Headlight bulbs

Sort by

Explore 4WD & Adventure

Showing 1 - 39 of 5638 products

2002 Nissan Navara headlight-bulbs — what they do and how to look after them

Headlight-bulbs are absolutely relevant and fitted on the 2002 Nissan Navara (D22). Technical sources including the 2002 Navara/D22 Owner’s Manual and the Nissan Factory Service Manual (FSM) — Lighting section — specify halogen headlamp bulbs. Most D22 variants use H4 12V 60/55W dual‑filament bulbs for low and high beam in a single globe, some trims with separate high beam list H1 12V 55W for the high beam. Market and trim can vary, so the bulb type is also moulded on the lamp housing (e.g., “H4”).

On this Navara, the headlight-bulbs handle the heavy lifting for safe night and low‑light driving, throwing a legal, well‑shaped beam onto the road and kerbside. They help the ute be seen in rain, fog and dawn/dusk, and keep it compliant with roadworthiness checks like WOF/regos under AU/NZ rules. Being halogen, they’re designed for stable colour and output when supplied with proper system voltage, and they sit behind a dust boot to keep moisture and grit out of the reflector.

During regular servicing, it’s smart to check brightness, beam aim, lens clarity and the condition of the connectors and dust boots. Halogen bulbs gradually dim with age, so if one fails or looks tired, replacing both sides keeps the light pattern even. Avoid touching the glass — skin oils can shorten bulb life. Stick with the specified wattage to protect the wiring and reflectors, going higher without dedicated relays and certified housings can cause heat damage and glare.

  1. Confirm bulb spec: typically H4 60/55W, some models use H1 for high beam. Check the owner’s manual, FSM, or the lamp housing marking.
  2. Access from behind the headlamp: disconnect the connector, peel back the rubber dust boot, then release the spring clip.
  3. Remove the old bulb, note the tab orientation, and fit the new bulb without touching the glass. If touched, clean with isopropyl alcohol.
  4. Refit the clip and dust boot, reconnect the plug, and repeat on the other side.
  5. Test low and high beam, then check beam aim using the adjusters, aim should meet ADR/WOF guidelines.
  6. Inspect lenses for haze, consider a proper restoration if the polycarbonate is cloudy to restore output.

Popular question: What headlight-bulb fits a 2002 Nissan Navara?

Most D22 Navaras run an H4 12V 60/55W halogen for combined low/high beam. Some trims with separate high beam use H1 55W for high. The exact type is in the owner’s manual and stamped on the lamp housing.

Popular question: How often should headlight-bulbs be replaced?

Replace when dim, colour‑shifted, or failed. Halogen bulbs can lose output over 2–3 years of typical use, so changing in pairs keeps the beam balanced and bright.

Popular question: Can LED bulbs be used instead?

Retrofitting LED bulbs into halogen housings may not meet ADR/WOF requirements and can cause glare if the optics aren’t designed for LEDs. If considering LEDs, use components that are properly tested and certified for road use in AU/NZ.

{ "@context": "https://schema.org", "@type": "FAQPage", "mainEntity": [ { "@type": "Question", "name": "What headlight-bulb fits a 2002 Nissan Navara?", "acceptedAnswer": { "@type": "Answer", "text": "Most D22 Navaras run an H4 12V 60/55W halogen for combined low/high beam. Some trims with separate high beam use H1 55W for high. The exact type is in the owner’s manual and stamped on the lamp housing." } }, { "@type": "Question", "name": "How often should headlight-bulbs be replaced?", "acceptedAnswer": { "@type": "Answer", "text": "Replace when dim, colour‑shifted, or failed. Halogen bulbs can lose output over 2–3 years of typical use, so changing in pairs keeps the beam balanced and bright." } }, { "@type": "Question", "name": "Can LED bulbs be used instead?", "acceptedAnswer": { "@type": "Answer", "text": "Retrofitting LED bulbs into halogen housings may not meet ADR/WOF requirements and can cause glare if the optics aren’t designed for LEDs. If considering LEDs, use components that are properly tested and certified for road use in AU/NZ." } } ]}