Your Selected Vehicle
Parts for your 2002 Mitsubishi Pajero-Headlight bulbs
Explore 4WD & Adventure
Narva 9-33 Volt LED Rear Stop/Tail, Right Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312R
$386
$289.50
Member Price
Narva Model 72 Rear Stop/Tail/Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable
$178
$133.50
Member Price
Narva Model 72 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable
$163
$122.25
Member Price
Product added to cart
2002 Mitsubishi Pajero headlight bulbs
Headlight bulbs are absolutely relevant to the 2002 Mitsubishi Pajero. The model uses replaceable halogen bulbs as a normal service item, as outlined in the Mitsubishi owner’s and workshop manuals for NM/NP-series vehicles and consistent with ECE R37/ADR requirements for replaceable light sources. In short: yes, this Pajero runs standard headlight bulbs, not sealed-beam units.
The purpose of the headlight bulb is simple but critical: deliver dependable low- and high-beam light so the driver can see and be seen, day or night, on bitumen or out bush. A healthy bulb maintains beam pattern, throw, and colour that match the headlamp optics—key for safety and for staying on the right side of Warrant of Fitness or roadworthy checks.
Most AU/NZ 2002 Pajero (NM) variants commonly use an H4 halogen 12V 60/55W for combined low/high beam. Some trims or markets may run separate bulbs (often H7 for low beam and H1 for high). Parker/position bulbs are typically small T10 wedges. Because trims vary, the best move is to check the owner’s manual or the marking on the headlamp’s rear cap for the exact type.
As part of routine servicing, bulbs should be inspected annually or every 15,000 km. Ageing halogens dim gradually, often shifting to a warmer colour before failure. Replace in pairs so beam colour and brightness stay matched, and keep a spare set in the glovebox if touring remote.
- Open the bonnet and access the rear of the headlamp.
- Unclip or twist off the dust cover, unplug the connector.
- Release the spring clip (if fitted) and remove the bulb.
- Avoid touching the glass. If touched, clean with isopropyl alcohol.
- Seat the new bulb correctly, secure the clip, refit the cover, reconnect, and test.
Handy tips: if moisture or fogging is present, replace the rubber boot and check for cracks in the housing. Don’t fit over-wattage bulbs—stick to ADR/E-marked options to protect wiring and avoid glare. If lighting seems weak even with fresh bulbs, look for UV-hazed lenses, tired earths, or voltage drop at the connectors, cleaning terminals or using quality replacements can restore full output.
After any bulb change, confirm headlight aim—especially if the vehicle’s been lifted or loaded for a trip. Correct aim prevents dazzling oncoming traffic and keeps night driving safe and relaxed.
Popular questions
What headlight bulb type does a 2002 Mitsubishi Pajero use?
Most 2002 Pajero NM models use an H4 12V 60/55W for combined low/high beam, while some trims may run separate H7 low and H1 high. Always confirm by checking the owner’s manual or the stamping on the headlamp cover.
Can LED bulbs be used instead of halogen?
LED retrofits in halogen housings may not be legal for on-road use in Australia or New Zealand unless the lamp assembly is approved as a unit. Even when physically compatible, beam pattern and glare can be an issue. For road use, choose ADR/E-marked solutions and check local regulations.
Why do new bulbs still seem dim?
Common culprits are voltage drop from corroded connectors or earths, UV-hazed lenses, or mis-aimed headlights. Clean or replace terminals, restore lenses if cloudy, and check aim. Also make sure not to touch the bulb glass during install—skin oils can shorten life and reduce output.
Popular Searches
