Parts for your 2002 Daihatsu Yrv-Exhaust mount

2002 Daihatsu YRV Exhaust Mount

Yes, the 2002 Daihatsu YRV uses exhaust mounts (rubber hangers). This is confirmed by technical sources including the Daihatsu Electronic Parts Catalogue for the M200/M201 series (Exhaust section, listing “mount” and “rubber, exhaust support”) and the YRV M200-series workshop/service manual, where exhaust removal/installation steps include detaching and refitting the mounting rubbers and brackets. Major aftermarket fitment guides for 2001–2005 YRV models also list exhaust mounting rubbers/hangers as service parts, which further verifies their use on this vehicle.

On the YRV, the exhaust mounts hold the exhaust system in the correct position under the car while isolating vibration from the cabin. They keep the front pipe, catalytic converter, centre section and rear muffler aligned, prevent metal-on-metal contact, and allow a small amount of movement as the engine rocks and the pipework heats and cools. Good mounts reduce noise, stop the tailpipe knocking on the body or rear beam, and minimise stress on flanges, welds and oxygen sensor wiring.

It’s smart to treat exhaust mounts as consumables. Rubber perishes with heat, road grime and age, so a 2002 vehicle will often benefit from fresh hangers. During routine servicing (say every 10,000–15,000 km), a quick inspection should look for cracks, splits, sagging, elongated holes or shiny rub points near the tailpipe. If the exhaust sits lower than usual, rattles on start-up or thumps on take-off over speed bumps, the mounts are likely tired. Replacement is straightforward: safely raise and support the car, lubricate the old rubbers with silicone spray, lever them off the pegs, and push new high-temp rubber hangers on. Refit any support brackets and ensure there’s even clearance around the muffler and heat shields.

For best results on a YRV, replace mounts in pairs or as a set so the system sits square. OE-style rubber gives factory comfort, stiffer polyurethane can last longer but may add a touch of vibration. Avoid cable ties or wire “fixes” — they transmit noise and can damage the exhaust or chassis. A brief post-fit check for leaks, knocks and tailpipe alignment finishes the job nicely.

• Common signs: rattles, thumps, sagging tailpipe, visible cracks in rubbers.
• Handy tools: silicone spray, exhaust hanger pliers, axle stands/jack stands.

Popular questions

How many exhaust mounts does a 2002 Daihatsu YRV have?
Most 2002 YRV variants use three to four rubber mounts: typically one near the front/centre section, one mid-span, and one or two at the rear muffler. Turbo or different trim levels may add a support bracket, but the layout is broadly similar across the range.

What are the symptoms of a worn YRV exhaust mount?
Expect rattles at idle, a dull thud on take-off or over bumps, a droopy tailpipe, or visible perishing in the rubber. Sometimes you’ll hear a metallic clink as the system taps a crossmember or heat shield.

Can the mounts be replaced at home?
Yes, with basic tools. Support the car securely, use penetrating oil or silicone spray on the old rubbers, and lever them off with hanger pliers or a flat screwdriver. Fit the new rubbers, check clearances, and you’re good to go. If bolts are badly corroded or brackets are bent, a workshop visit is sensible.