Parts for your 2002 Daihatsu Gran move-Driveshafts

2002 Daihatsu Gran Move Driveshafts

Driveshafts are absolutely relevant to the 2002 Daihatsu Gran Move. The model is a front‑engine, front‑wheel‑drive small MPV (also known as the Daihatsu Pyzar), and it uses a left and right front driveshaft (CV axle) to transmit torque from the transaxle to the front wheels. This layout is documented in the Daihatsu Gran Move/Pyzar Workshop Manual (Drivetrain/Front Axle section) and the Daihatsu Electronic Parts Catalogue (G30# series), both of which list complete LH/RH driveshaft assemblies with inner tripod and outer CV joints. Being FWD, there’s no rear propeller shaft on the Gran Move.

On the 2002 Daihatsu Gran Move, the driveshafts do the heavy lifting every time the car moves off the mark, turns, or rides a bump. Each shaft has CV (constant velocity) joints that keep power delivery smooth while the suspension works and the wheels steer. When everything’s right, it’s quiet, vibration‑free motoring. When things wear, owners will usually hear clicking on tight turns, feel shudder under load, or spot grease flung around the inside of a wheel from a split CV boot.

As part of routine servicing, it pays to keep an eye on these items. In Aussie and Kiwi conditions—think corrugations, potholes, coastal salt, and plenty of stop‑start driving—boots and clamps cop a hard life. Catching a torn boot early can save a joint from premature failure.

• Inspect CV boots and clamps at each service or every 10,000–15,000 km, look for tears, cracks, or grease misting.
• If a boot is damaged but the joint is quiet and free of play, a boot‑only repair with fresh CV grease is fine.
• If there’s clicking on turns, vibration under acceleration, or gritty movement, replace the complete driveshaft assembly.
• Always use new axle nuts, circlips, and hub cotter pins where specified, and torque to factory specs from the Daihatsu manual.
• After removal, check the transaxle oil seal for weeping and top up or replace fluid as needed.
• Post‑fitment, road test for noise and vibration, a wheel alignment check is wise if suspension was disturbed.

Quality parts and correct torque go a long way. Done right, Gran Move driveshafts can run for well over 150,000 km, especially if the boots stay intact. Regular checks also help with WOF/regos and keep the little Daihatsu feeling tight and tidy.

Popular questions about 2002 Daihatsu Gran Move driveshafts

Does the 2002 Daihatsu Gran Move have rear driveshafts?
No. It’s a front‑wheel‑drive setup, so it only uses front driveshafts (CV axles). There’s no rear prop shaft on this model. All torque is sent through the transaxle to the left and right front shafts.

How long do Gran Move driveshafts and CV joints typically last?
With intact boots and fresh grease, they can last well beyond 150,000 km. Harsh roads, torn boots, or water ingress shorten that lifespan, so regular inspections are key.

Can the CV boot be replaced without changing the whole driveshaft?
Yes. If the joint isn’t noisy or worn, a boot‑only repair is a cost‑effective fix. If there’s clicking, roughness, or excessive play, it’s better to replace the complete shaft.