Your Selected Vehicle
Parts for your 2001 Nissan Primera-Exhaust mount
Explore 4WD & Adventure
2001 Nissan Primera exhaust-mount — purpose, care, and when to replace
Yes, the 2001 Nissan Primera uses exhaust mounts. Technical sources including the Nissan Primera Factory Service Manual (EX – Exhaust System, P11/P12), the Nissan FAST electronic parts catalogue, and the Haynes Service and Repair Manual for Primera models show the exhaust and muffler assemblies supported by multiple rubber insulators (hangers) and brackets. So “exhaust-mount” is absolutely relevant to this model.
On a 2001 Primera, exhaust mounts are the rubber insulators that suspend the exhaust from the body. Their job is to isolate vibration and noise, keep the pipework aligned, and maintain safe clearances to the floor, heat shields, suspension and bumper. Good mounts stop the tailpipe banging over bumps, reduce drone in the cabin, and help prevent stress cracks at flanges and the flex joint.
Given the age of these cars, original rubbers are often perished, cracked or stretched. Tell-tales include a sagging tailpipe, clunks or rattles on start-up or over corrugations, visible splits in the rubber, melted spots near the rear box, or fresh leaks appearing at joints because the system is hanging skew-whiff.
Replacement is straightforward with the right prep and a bit of lube. It’s smart to renew mounts as a set (there are typically three to five along the system, depending on body style and exhaust type). Many owners stick with quality OEM-style rubber, polyurethane options can last longer but may transmit a touch more vibration.
- Inspect mounts at each service or every 10,000–15,000 km, and after any big knock or off‑road excursion.
- Safely raise and support the car, support the exhaust to avoid stressing the flex joint.
- Spray the old rubbers with silicone spray or soapy water (avoid petroleum products on rubber).
- Swap the insulators like-for-like, note any orientation marks or tabs on OEM parts.
- Check all brackets for rust, confirm clearances all round, then tighten fasteners to Nissan specs from the service manual.
Done right, fresh mounts restore the exhaust height and hush up those annoying bangs and buzzes. It’s an inexpensive job that makes the Primera feel tight and tidy again.
Popular questions about 2001 Nissan Primera exhaust-mount
How many exhaust mounts does a 2001 Primera have?
Most have three to five: typically one near the front/centre pipe, one around the mid-section, and two at the rear muffler. Exact count varies with body style and whether the car has an aftermarket system.
What are the symptoms of a worn exhaust mount?
Rattles or thumps over bumps, a droopy tailpipe, buzzing at idle, or the exhaust tapping the subframe or heat shield. You might also see cracked or elongated rubbers when you look under the car.
Should I choose polyurethane or rubber mounts?
Rubber is closest to factory feel and keeps noise down. Polyurethane can last longer and hold position better but can add a smidge of vibration. For daily driving, quality rubber is usually the pick, for longevity or performance, poly can make sense.
