Your Selected Vehicle
Parts for your 2001 Daihatsu Gran move-Headlights
LED Autolamps 12/24V LED Green Emergency Lamp Flash Patterns With Sunc WireStrobe High Power - 120033GM
Explore 4WD & Adventure
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker RHS Multivolt - 805ARIMR
LED Autolamps Interior LED Light 12v Blue Lens Chrome Housing 10cm Cable Blister Pack - 68B
LED Autolamps Multi Fit Steel Bracket To Suit 280/282/275/80/283/284 Triple Combination Lamps - MFBKT
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 385 Series Rear Combination Lamp RHS with 7 core plug - 385ARWMRCSB
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps 90 Series Red Emergency LED Strobe/Warning Light 12V/24V Surface Mount - 90RM
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12V Interior Strip lamp Touch Sensor Switch With MCU Circuitry - 40260SMCU
LED Autolamps Multi Volt Rear Indicator Lamp With 8 Square LEDs Blister Pack With Black Base - 135AM
2001 Daihatsu Gran Move Headlights — Purpose, Care and Replacement
Headlights are absolutely fitted to the 2001 Daihatsu Gran Move and are essential for road use. This is supported by the Daihatsu Gran Move/Pyzar owner’s manual and parts catalogues for the late-1990s to early-2000s models, which list front headlamp assemblies and halogen bulbs. Road rules in Australia and New Zealand also require compliant headlamps on passenger vehicles, aligning with UN ECE lighting regulations for installation and performance.
On the Gran Move, the headlights provide safe forward visibility at night and in poor weather while ensuring the car is seen by others. Most examples use a dual‑filament H4 60/55 W halogen bulb for high and low beam in a single reflector unit, with a separate small wedge bulb for the park light. Always confirm bulb types in the owner’s manual or against the existing lamp.
As part of regular servicing, it pays to give the Gran Move’s headlights a quick once‑over. Check for dimming, flicker, moisture inside the lens, yellowing of the plastic, damaged connectors, and blown fuses. Replace bulbs in pairs to keep the beam colour and brightness consistent left to right. If the lenses are hazy, a reputable headlight restoration kit can restore clarity and improve beam performance.
Basic bulb swap steps (typical H4 setup):
- Open the bonnet and locate the rear of the headlamp. Disconnect the three‑pin H4 plug.
- Peel off the rubber dust cap.
- Unclip the spring retainer and withdraw the bulb.
- Install the new bulb without touching the glass, refit the clip and dust cap, then reconnect the plug.
Handy tips:
- Never touch the glass of a halogen bulb, oils can cause hot spots and early failure.
- Stick to the correct wattage to avoid wiring and reflector damage.
- Inspect headlight aim after any bulb or front‑end work. Mis‑aimed lights can fail a WOF (NZ) or RWC (AU) and reduce night vision.
- If you spot condensation, check the rear cap seal and vent, minor fogging after rain can be normal, persistent moisture is not.
- A dab of dielectric grease on connectors can help ward off corrosion, especially on older looms.
A quick headlight check at each service interval (around 10,000 km or six months) keeps the Gran Move shining bright and legal on Aussie and Kiwi roads.
Popular questions about 2001 Daihatsu Gran Move headlights
What headlight bulbs does a 2001 Gran Move use?
Most 2001 Gran Move models use an H4 60/55 W halogen for high/low beam and a T10 wedge for the park light. Variations can exist by market and trim, so it’s smart to verify against the existing bulb or the owner’s manual.
How often should headlight bulbs be replaced?
There’s no strict interval, replace on failure or noticeable dimming. Check operation and lens condition at each service. Replace in pairs to keep beam colour and brightness matched.
How do you adjust the headlight aim?
Use the adjuster screws on the back of each headlamp. Park on level ground facing a wall or aiming screen and follow a standard ECE/ADR pattern. If you’re unsure, a workshop can set the aim correctly to meet WOF/RWC standards.