Your Selected Vehicle
Parts for your 2000 Toyota Hiace-Batteries
Narva Model 70 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable, Bulk Pack Of 4 - 97010-1/4
Narva 9-33 Volt LED Rear Stop/Tail and direcion indicator and reverse lamp with in built retro reflector and 0.5m hard wired cable - 97310
Narva 9-33 Volt LED Rear Stop/Tail, Left Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312L
Explore 4WD & Adventure
Narva Model 18 LED Side Marker/Cabin Marker/FEOM Light Amber 10-30V - 91800
Narva 9-33 Volt Surface Mount LED Side marker lamp(red/amber) with Chrome cover and 0.5m cable - 96802
Narva Model 70 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable And Dt Plug - 97010-1-D
Narva 9-33 Volt Surface Mount LED Side directional indicator(amber) with Black cover and 0.5m cable - 96842B
9-33 Volt LED Rear Direction Indicator and Twin Stop Lamps with LED Tail Rings - 94364C
2000 Toyota Hiace Batteries
Yes, a battery is absolutely relevant to the 2000 Toyota Hiace. Technical sources like the Toyota owner’s manual and Electrical Wiring Diagram for the Hiace (H100 series), along with Australian and New Zealand fitment catalogues from Century Yuasa and Exide, specify a 12‑volt starting battery as standard equipment across petrol and diesel variants. Those references make it clear the Hiace relies on a conventional 12 V lead‑acid battery to crank the engine and power vehicle electrics when the alternator isn’t spinning.
On a 2000 Hiace, the battery’s job is straightforward but critical. It delivers high cranking amps to spin the starter, feeds the glow plugs on diesel models, and stabilises voltage for lights, ECU, immobiliser, stereo, and accessories. It also buffers the electrical system, smoothing alternator output so everything from wipers to the fridge in a camper conversion behaves as it should.
For servicing, most owners can expect 3–5 years of battery life in Aussie and Kiwi conditions, depending on heat, short-trip use, and accessory load. If cranking gets sluggish, dash lights flicker, or the battery warning stays on, it’s time for a test or replacement. A quick health check during routine servicing—state of charge, conductance/load test, and charging voltage—catches issues early. The alternator should typically show around 13.8–14.6 V at the terminals with the engine running and some load on.
- Choose the right spec: 12 V starting battery with enough CCA for the engine (diesels need more), correct terminal layout and case size to fit the tray and clamp.
- If the van runs extra accessories or a camper setup, consider higher reserve capacity or a dual‑battery system with an isolator.
- Keep terminals clean and tight, use a proper hold‑down, and avoid deep discharges.
- For serviceable flooded types, check electrolyte levels