Parts for your 2000 Nissan Serena-Pedal pads

2000 Nissan Serena pedal pads — what they do and when to replace them

Pedal pads are absolutely used on the 2000 Nissan Serena (C24). Nissan’s Electronic Parts Catalogue (FAST) for the C24 platform lists a rubber brake pedal pad for all variants and a clutch pedal pad on manual models, and the C24 service manual calls for inspection and replacement if worn. That lines up with local roadworthiness guidance too — NZTA’s VIRM and Australian roadworthy checks require non‑slip pedal rubbers on service brakes, so the Serena leaves the factory with them fitted.

On this model, the pedal pads are the hard‑wearing rubber covers that sit over the metal pedal plates. They give shoes solid grip in the wet, damp vibrations, protect the pedal surface, and keep the pedal height and feel consistent. Automatic Serenas have a brake pedal pad, manual versions have both brake and clutch pads. The accelerator is usually a one‑piece plastic tread without a separate rubber cover.

There’s no set kilometre interval — the trick is to inspect the pads at each service. City stop‑start driving, sandy beaches, or wet boots will wear them faster. If the surface gets glassy‑smooth, cracked, hardened or the edges are missing, it’s time. Slippery pedals are more than a nuisance, they can fail a WOF/RWC and make emergency braking sketchy.

• Signs it’s due: shiny or slippery surface, splits or chunks missing, thin or uneven wear, pad moving on the plate.

Swapping a Serena pedal pad is a quick, no‑dramas job:

1. Peel off the old rubber and clean the metal pedal with a mild degreaser.
2. Warm the new pad in hot water for a minute to make it pliable.
3. Hook the top lip over the pedal, then roll it down until all edges seat in the groove. Check it’s fully captured.

Go for an OEM‑style pad matched to your VIN — automatics use a wider brake pad than some manual setups, and clutch pads differ. Avoid metal bolt‑on “racer” covers that can slip or foul floor mats. Keep mats clipped and clear of the pedal swing, don’t dress pads with silicone, and just wash them with soapy water when they look grubby.

They’re a cheap part that makes a big difference to feel and safety, and on a 2000 Serena, replacements are easy to source and fit — sorted.

FAQs

Does the 2000 Serena’s accelerator have a removable pedal pad?
Typically, no. The accelerator is a moulded plastic tread without a separate rubber cover. If it’s slippery, clean it with mild soap and water. If the surface is worn smooth or damaged, the fix is usually replacing the pedal assembly rather than a pad.

How often should pedal pads be replaced?
There’s no fixed schedule. Replace them whenever they’re smooth, hard, cracked or loose. Many owners find brake pads last anywhere from 60,000 to 150,000 km depending on driving and footwear. If a WOF/RWC check notes a slippery surface, fit a fresh pad straight away.

Can aftermarket pedal pads be used?
Yes, as long as they’re OEM‑style rubber covers that fit the Serena’s pedal plate snugly. Avoid bolt‑on metal covers — they can reduce grip and may not meet roadworthy expectations. Make sure the pad seats fully and doesn’t interfere with floor mats.