Parts for your 2000 Nissan Pathfinder-Pedal pads

2000 Nissan Pathfinder Pedal Pads

Based on technical references including the 2000 Pathfinder (R50) Factory Service Manual (Brake and Clutch sections) and Nissan’s FAST parts catalogue, the 2000 Nissan Pathfinder is fitted with replaceable rubber pedal pads. The brake pedal has a serviceable rubber pad, manual-transmission models also have a clutch pedal pad, and most Australian/NZ Pathfinders use a foot-operated parking brake with its own pad. The accelerator typically has an integral textured face, not a separate rubber pad.

On this model, pedal pads are the grippy rubber covers that sleeve over the metal pedal plates. They provide secure footing for boots and shoes, reduce vibration, and help the vehicle meet safety expectations for non-slip pedal surfaces. When they harden, crack or go smooth, braking and clutch control can be compromised—especially in the wet—so keeping them in good nick is a simple, high-value safety win.

• Common wear signs: shiny or slippery surfaces, hardened or cracked rubber, curled edges, exposed metal, or feet slipping under light moisture.
• Check at each service or about every 10,000 km, more often if the vehicle sees off-road mud, beach work, or lots of city stop–start.

Cleaning and care are straightforward: wipe with mild soapy water, rinse and dry. Avoid petroleum-based cleaners that can harden or swell the rubber. Make sure floor mats can’t slide up and ride the pedal face, anchor them properly.

Replacement is a quick DIY job and a good add-on during routine servicing. Genuine parts or quality aftermarket pads both work—just match transmission type and right-hand drive fitment. If the accelerator surface is worn, the fix is typically a pedal assembly replacement rather than a separate pad.

1. Park safely, key off, and give yourself good lighting.
2. Peel off the old pad from one corner and remove it fully.
3. Warm the new pad slightly (sunlight or warm water) so it’s more flexible.
4. Hook the bottom lip first, stretch over the sides, then seat the top lip all the way around.
5. Press all edges to confirm a full, even fit, test pedal feel with dry and slightly damp footwear.

If a brake or clutch pad is missing or excessively worn, the vehicle may struggle to meet WOF/RWC expectations due to the increased slip risk. Given the low cost and short install time, replacing tired pads is an easy safety upgrade for any 2000 Pathfinder owner.

FAQs

Which pedals on a 2000 Pathfinder have replaceable pads?
Brake and clutch (on manuals) use replaceable rubber pads, and most foot-operated parking brakes have a pad as well. The accelerator typically has an integrated textured face rather than a separate pad.

How often should pedal pads be replaced?
Inspect at every service or around 10,000 km. Replace when the surface is smooth, cracked, hardened, or when edges lift. In wet or muddy use, they can wear faster—budget to change them sooner if you notice any slip.

Are aftermarket alloy pedal covers OK to use in Australia or New Zealand?
They’re fine if they’re securely mounted, non-slip, and don’t interfere with pedal travel or floor mats. The key is maintaining safe grip and full pedal control to meet local safety expectations.