Parts for your 2000 Daihatsu Gran move-Exhaust mount

2000 Daihatsu Gran Move Exhaust Mount

Yes, an exhaust-mount is used on the 2000 Daihatsu Gran Move. Technical references that cover this model — including the Daihatsu Gran Move/Pyzar (G3 series) workshop manual exhaust section, the Daihatsu electronic parts catalogue for G303/G313 chassis codes, and aftermarket fitment catalogues from established exhaust suppliers — all specify rubber exhaust hangers/insulators to support the exhaust system along the underbody. So an exhaust-mount is absolutely relevant for this vehicle.

On the Gran Move, the exhaust-mount’s job is to suspend the exhaust under the car while isolating vibration. Those little rubber hangers stop the pipe and muffler from knocking on the body and keep exhaust stresses away from the manifold and flex sections. Over time, rubber perishes with heat, age, road grime, and a bit of coastal life. When they stretch or crack, the exhaust can sag, rattle, or clunk on bumps.

During regular servicing, it’s smart to have a quick look at all the exhaust mounts. Most Gran Move examples run several rubber insulators from the front pipe area through to the rear muffler. A simple visual check under the car will spot perished, split, or oil-soaked rubbers. If any mount looks tired, replacing them as a set is cheap insurance and helps keep the exhaust aligned.

• Common signs they’re due: exhaust tapping the floor, rattles at idle, tailpipe sitting off-centre, or extra vibration in the cabin.
• Good practice: support the exhaust with a jack stand before removing any mount so there’s no strain on the manifold or studs.
• Removal tip: a little silicone spray or soapy water helps slide the rubber off the pegs, avoid petroleum-based products that can attack rubber.
• Refit: use quality rubber insulators matched to the peg spacing and thickness, tighten any bracket hardware to the workshop manual spec.

There’s no strict replacement interval, but in Aussie and Kiwi conditions a check at every service and proactive replacement every few years isn’t a bad shout, especially if the car sees rough roads. If the Gran Move has had an aftermarket exhaust fitted, confirm the mounts aren’t preloaded or twisted — a relaxed, neutral fit prevents early failure. Keep it simple: fresh rubbers, correct alignment, and the old Daihatsu will stay quiet and comfy.

What are the symptoms of a failing exhaust mount on a 2000 Gran Move?

Owners often notice a hollow rattle at idle, a thump over speed bumps, or the tailpipe sitting low or skewed. Cabin buzz can also creep in when the rubber has gone soft or split. If it’s left too long, extra movement can stress joints and lead to leaks.

Can universal exhaust rubbers be used on a Gran Move?

Yes, as long as the hole spacing, thickness, and peg diameters match the original layout. Many universal “insulators” fit fine, but the best bet is a known-fit equivalent from a reputable brand to avoid premature sagging.

How often should the exhaust mounts be replaced?

There’s no fixed schedule, inspect at every service. In warmer or coastal areas, they may need replacing every 2–4 years, or sooner if you hear rattles or see visible cracking, elongation, or oil contamination.