Parts for your 1999 Toyota Crown-Pedal pads

1999 Toyota Crown pedal pads

Technical references — including the Toyota Electronic Parts Catalogue (EPC) for the S170-series Crown (1999–2003), Toyota Crown Chassis & Body repair/service literature, and common aftermarket parts catalogues — confirm that pedal pads are indeed fitted to the 1999 Toyota Crown. There’s a replaceable rubber pad on the brake pedal, and on the clutch pedal for manual variants. On most automatic Crowns of this era, the accelerator uses an integrated plastic tread as part of the pedal, not a separate rubber pad.

For this model, the brake (and clutch, where fitted) pedal pads do the simple but vital job of providing grippy, cushioned contact so the driver’s shoe won’t slip, especially in the wet. They also damp vibration and help protect the metal pedal plate from wear. Over time, the rubber perishes, hardens, or the raised ribs wear flat — that’s the cue for replacement as part of routine servicing.

Good workshops in Australia and New Zealand will check pedal pad condition during scheduled services. It’s worth replacing pads at the first signs of:

• Cracking, glazing, or a hard, plasticky feel
• Ribs worn smooth or peeling edges
• Noticeable slipperiness when shoes are damp

Replacement is quick and inexpensive. The old pad peels off the pedal plate, the new one stretches on. Warming the new rubber (sunlight or warm water) makes it more pliable. While the pad is off, the tech should check the pedal plate for rust or burrs and clean the area. On manual Crowns, it’s smart to replace the clutch and brake pads as a pair so grip feels consistent side to side. For automatic models, confirm whether the accelerator is an integrated plastic tread, if so, clean it with mild detergent and avoid silicone dressings that can turn it slippery.

Best practice in local conditions is to keep the area clean of grit and road grime, ensure floor mats are correctly clipped so they can’t foul the pedals, and stick with genuine or high-quality aftermarket pads that match the Crown’s pedal plate shape. After fitment, a short, safe test drive helps confirm firm, sure-footed pedal feel.

FAQs

Does a 1999 Toyota Crown have pedal pads?
Yes. The S170-series Crown (1999) has a rubber brake pedal pad, and manual versions also have a clutch pedal pad. The accelerator on most automatic cars uses an integrated plastic tread rather than a separate rubber cover.

How often should the pedal pads be replaced?
There’s no strict kilometre interval — replace them when the ribs are worn flat, the rubber is cracked or hard, or the pedal feels slippery. In Aussie and Kiwi climates, that can be anywhere from a few years to a decade depending on use and storage.

Are aftermarket pedal pads OK for a Crown?
They’re fine if they’re a proper match to the Crown’s pedal plate and meet local standards. Avoid universal “sport” covers that can shift or foul the pedal. A snug, model-correct fit is key to safe operation.