Skip to content Skip to navigation menu

Your Selected Vehicle

Parts for your 1999 Mitsubishi Pajero-Wiper refills

Sort by
Showing 1 - 4 of 4 products

1999 Mitsubishi Pajero wiper-refills

Yes, wiper-refills are relevant to the 1999 Mitsubishi Pajero. Mitsubishi’s genuine parts catalogues for the V20/V60 series (1998–2000) list “wiper blade rubber” as a replaceable service item for both front and rear positions, and the Owner’s/Service Manuals specify replacing worn wiper rubber to maintain clear windscreen vision. Major aftermarket application guides (Bosch, Trico) for the 1999 Pajero also offer insert-style refills, confirming the vehicle was supplied with conventional, refillable framed wiper blades from factory.

On this Pajero, the wiper-refill is the rubber insert that slides into the existing metal or plastic blade frame. Its job is simple but critical: sweep water, road grime, salt spray, and mud off the windscreen so the driver can see clearly in wild Kiwi or Aussie weather. Refills are a cost-effective, waste-reducing option compared with replacing the whole blade assembly, provided the original-style frame is still fitted.

Typical fitments for many 1999 Pajero wagons are around 530 mm (driver), 500 mm (passenger), and approximately 350 mm for the rear, with common insert widths of about 6 mm (front) and narrower on some rear arms. Variations exist by body and market, so it’s smart to confirm lengths and refill width against the VIN, existing blade frames, or a reputable parts catalogue. If the vehicle has been upgraded to modern beam/aero blades, those are usually not refillable—replace the complete blade instead.

As part of routine servicing, check the wiper-refills every 6 months or 10,000 km, and plan on annual replacement—sooner if the vehicle lives in harsh sun, salty coastal air, or sees lots of off-road dust. Keep the windscreen and rubber clean with mild washer fluid, avoid petroleum-based cleaners that can harden the rubber.

  • Replace when there’s streaking, chattering, missed patches, or split edges.
  • Wipe the rubber with a damp cloth after dusty or muddy trips.
  • Inspect the blade frame: if it’s bent or the claws are loose, go for a complete blade assembly.
  • Test wipe after fitting, ensure the insert locks fully into the frame end clip.

Done right, fresh refills keep the Pajero’s windscreen clear, cut glare on wet nights, and make those long-haul drives far less tiring.

Popular questions about 1999 Mitsubishi Pajero wiper-refills

Are wiper-refills or full blades better for a 1999 Pajero?
Refills are ideal if the original-style framed blades are in good nick—cheaper and less waste. If the frames are rusty, bent, or the vehicle runs beam/aero blades, replace the whole blade. Both options work, pick based on the blade style that’s fitted and frame condition.

What size wiper-refills does a 1999 Pajero use?
Many 1999 Pajeros take roughly 530 mm (driver), 500 mm (passenger), and about 350 mm rear, with common 6 mm front insert width. Always confirm against the current blades, VIN, or a parts guide, as sizes can vary by model and rear arm design.

How often should the refills be replaced in Australia or New Zealand?
Plan for every 12 months, or sooner if you notice streaking or noise. UV, heat, salt, and dust accelerate wear, so coastal and outback use may mean more frequent changes.

{ "@context": "https://schema.org", "@type": "FAQPage", "mainEntity": [ { "@type": "Question", "name": "Are wiper-refills or full blades better for a 1999 Pajero?", "acceptedAnswer": { "@type": "Answer", "text": "Refills are ideal if the original-style framed blades are in good condition—cheaper and less waste. If the frames are rusty, bent, or the vehicle runs beam/aero blades, replace the whole blade. Both options work, pick based on the blade style that’s fitted and frame condition." } }, { "@type": "Question", "name": "What size wiper-refills does a 1999 Pajero use?", "acceptedAnswer": { "@type": "Answer", "text": "Many 1999 Pajeros take roughly 530 mm (driver), 500 mm (passenger), and about 350 mm rear, with common 6 mm front insert width. Always confirm against the current blades, VIN, or a parts guide, as sizes can vary by model and rear arm design." } }, { "@type": "Question", "name": "How often should the refills be replaced in Australia or New Zealand?", "acceptedAnswer": { "@type": "Answer", "text": "Plan for every 12 months, or sooner if you notice streaking or noise. UV, heat, salt, and dust accelerate wear, so coastal and outback use may mean more frequent changes." } } ]}