Parts for your 1999 Mitsubishi Lancer-Wiper blades

1999 Mitsubishi Lancer wiper blades

Based on technical references including the 1999 Mitsubishi Lancer (CE series) owner’s manual and fitment catalogues from Trico ANZ and Bosch ANZ, this vehicle is fitted with front windscreen wiper blades on standard hook-style arms. Rear wiper blades appear only on hatch and wagon variants, not on the sedan. So yes—wiper blades are absolutely relevant and used on the 1999 Mitsubishi Lancer.

Wiper blades do a lot more than just clear drizzle. On a Lancer of this vintage, they’re essential for safe visibility in sudden downpours, motorway spray, and winter road grime. Fresh blades sweep the screen cleanly, reduce glare from oncoming lights, and help the demister work efficiently because the glass stays free of film and streaks. Poor wipers can be grounds for a WOF failure in New Zealand and a roadworthy knock-back in Australia, so they’re not a “nice to have”—they’re a must-have.

As part of routine servicing on a 1999 Lancer, it’s smart to inspect the wipers every service and replace them about every 6–12 months, sooner if exposed to harsh sun, salty coastal air, or lots of bush tracks. The common front sizes for this model are typically around 530 mm (21") on the driver’s side and 475 mm (19") on the passenger’s side, with a rear blade (around 300–305 mm) on hatch/wagon models. Always confirm by measuring the existing blades or checking a trusted fitment guide for the exact body style and market.

• Telltale signs it’s time to swap: streaks or haze, chattering or squeaks, split or jagged rubber edges, and missed patches at the ends of the sweep.

Maintenance is simple and pays off. Wipe the rubber edge with a damp cloth and mild soapy water every month to clear grit that causes chatter. Keep the washer bottle topped with proper screen wash, not plain water. Don’t run the wipers on a dry screen, and in frost, free the blades before switching them on. If the arm spring is weak or the pivot is sloppy, address that as part of the service so new blades can do their job.

When replacing, hook-style blades click straight in—follow the insert’s arrows and listen for a positive lock. Beam or hybrid blades offer better all-weather contact than old-style metal-framed refills, but refills are fine if the frames are tidy. After fitting, test on a wet screen and check the parking position. A well-sorted wiper setup on a 1999 Lancer makes wet-weather driving far less stressful.

Popular questions about 1999 Mitsubishi Lancer wiper blades

What size wiper blades fit a 1999 Mitsubishi Lancer?
Most CE-series Lancers take approximately 530 mm (21") on the driver’s side and 475 mm (19") on the passenger’s side. Hatch and wagon variants usually add a rear blade around 300–305 mm. Because trims and arms can vary, it’s best to measure your current blades or check a reputable ANZ fitment guide.

Going a size longer can cause tip-lift or clash at the A‑pillar, so stick close to the recommended lengths for clean, quiet operation.

Does the 1999 Lancer have a rear wiper?
Sedan models typically do not. Hatch and wagon versions generally do and will need a separate rear blade, commonly around 300–305 mm. Confirm by checking the tailgate arm and blade type before ordering.

How often should the blades be replaced?
Plan on every 6–12 months. In hotter, coastal, or high-UV areas of Australia and New Zealand, rubber ages faster—if you notice streaks, chatter, or split edges, change them sooner. Regular cleaning with mild soapy water can stretch their lifespan between swaps.