Your Selected Vehicle
Parts for your 1998 Suzuki Swift-Headlight bulbs
Explore 4WD & Adventure
Repco by Century Car Battery Superior Performance 330CCA - NS40Z MF
LED Autolamps 12/24V LED Number Plate Light LED With 0.14M Lead (2 pce) - 30BLM
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflector 100x100x22mm - 101BAR
LED Autolamps 12/24V LED Stop/Tail Lamp With Red Lens Round With Grommet/Plug - 113RMG
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Amber Red LED Light - 282ARWM
LED Autolamps 10/30V Rear Position Marker 2 Red LEDs With 40cm Wire Blister Pack - 58RM
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reverse Lamp 200x50x28mm Twin Blister - 200BIRSTME2
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
1998 Suzuki Swift headlight-bulbs — what they do and how to look after them
Headlight-bulbs are absolutely relevant to the 1998 Suzuki Swift. Technical references including the 1998 Suzuki Swift (SF series) owner’s manual and the Suzuki Genuine Parts catalogue specify a replaceable H4 12V 60/55W halogen bulb for the headlamps. Industry bulb guides from major lighting manufacturers also list H4 for this model across AU/NZ variants, confirming it’s a standard halogen reflector setup rather than a sealed-beam or HID unit.
On a ’98 Swift, the headlight-bulbs provide both low and high beam via a dual‑filament H4, giving clear forward vision at night and helping oncoming traffic see the car. Because halogen output fades with age, even before a filament blows, keeping bulbs fresh is a simple way to boost safety and stay compliant with local roadworthy/WOF checks.
For servicing, it’s smart to replace headlight-bulbs in pairs so beam colour and brightness match. Stick with 12V 60/55W H4 to avoid cooking wiring or reflectors, higher‑wattage bulbs can overheat and may not be legal without upgraded looms and relays. If extra punch is needed, choose ADR/ECE‑approved “plus” performance H4s rather than upping wattage.
Typical replacement steps are straightforward: unplug the three‑pin connector at the rear of the lamp, peel back the rubber boot, release the spring clip, remove the old H4, and seat the new bulb with the locating tab correctly oriented. Avoid touching the glass, fingerprints can create hot spots and shorten life. Reseat the clip, refit the boot, and reconnect the plug, then test both beams.
During a service, it’s worth checking aim and lens condition. Cloudy lenses or moisture inside the housing will dull output, polish the lens if it’s hazed and sort any seal leaks. If a new bulb doesn’t light, check the fuse, relay, and earth connections at the headlamp. Many owners do a quick headlight check every few months or before long night drives.
- Bulb spec: H4 (HB2/9003 equivalent), 12V 60/55W halogen
- Replace in pairs for even light and colour
- Don’t touch the glass, use gloves or a clean tissue
- Verify beam aim after any bulb change
FAQs
What bulb type fits a 1998 Suzuki Swift?
Most AU/NZ 1998 Swifts take an H4 12V 60/55W halogen bulb for both low and high beam. Trim levels and aftermarket headlamp assemblies can vary, so it’s wise to check the stamping on the headlamp or the owner’s manual before buying. Avoid higher‑wattage bulbs unless the wiring has been upgraded and the setup remains road‑legal.
How do you change the headlight-bulb on a ’98 Swift?
Open the bonnet, unplug the 3‑pin connector from the back of the headlamp, peel off the rubber dust boot, then unclip the spring retainer. Swap in the new H4 (don’t touch the glass), refit the clip and boot, reconnect the plug, and test low/high beam. If the beam pattern looks off, adjust the aim using the headlamp adjusters.
Should headlight-bulbs be replaced in pairs?
Yes, it’s recommended. Halogen bulbs dim over time, so a single fresh bulb can look brighter and a different colour to the older side. Replacing both keeps light output even and avoids one side failing soon after the other.