Parts for your 1998 Holden Barina-Exhaust mount

1998 Holden Barina exhaust mount — what it does and when to replace it

Yes, the 1998 Holden Barina (SB, based on the Opel/Vauxhall Corsa B) is fitted with exhaust mounts. Technical sources that confirm this include the GM Holden Barina SB Service Manual (1997–2000) Exhaust System section, the GM/Opel Electronic Parts Catalogue for Corsa B which lists rubber “silencer” mounts for the centre and rear muffler, and the Haynes Vauxhall/Opel Corsa 1993–2000 manual (No. 3506) which details inspection and renewal of exhaust mounting rubbers. So an exhaust-mount is absolutely relevant to this model.

On a 1998 Barina, the exhaust mounts (also called hangers or rubbers) are tough little rubber isolators that hold the exhaust system up under the car while soaking up engine movement and road vibes. They stop the muffler and pipes from banging on the body or rear beam and keep the tailpipe sitting where it should. When they harden, split or go saggy, owners usually notice rattles over bumps, a thudding noise on take-off, or a crooked tailpipe. Left too long, a failed mount can stress joints and flanges, leading to leaks or cracked welds.

As part of routine servicing, it’s smart to give the Barina’s exhaust mounts a quick look every 10,000–15,000 km, or at each oil change/WOF inspection. A torch and a gentle wiggle test are enough: check for cracks, perishing, shiny witness marks where the exhaust has touched the body, and excessive movement. On the SB Barina, expect a centre mount near the mid-pipe and one or two at the rear muffler.

• Replace mounts if they’re cracked, hardened, stretched, or if the exhaust sits low or knocks.
• Use quality rubber (or polyurethane if you want a firmer feel) matched to the Barina’s hanger peg size.
• Support the exhaust with a jack and block of wood before removal to avoid stressing the flex joint.
• A dab of silicone spray helps slide old rubbers off and new ones on without a wrestle.
• After refit, check tailpipe alignment and clearance to the bumper, beam and heat shields.

Most mounts are inexpensive and can be swapped at home with basic tools. If a mount has failed, it’s also worth inspecting adjacent clamps and the rear muffler strap/bracket for fatigue, as a tired mount can pass extra load to those parts.

Popular questions about 1998 Holden Barina exhaust mounts

How many exhaust mounts does a 1998 Barina have?

Typically, an SB Barina has a centre mount supporting the mid-pipe and one or two rubber mounts at the rear muffler. Exact count can vary with trim and replacement exhausts, but expect two to three in total. A quick visual check under the car will confirm what’s fitted.

What are the signs an exhaust mount needs replacing on a Barina?

Common clues are a knocking or rattling sound over bumps, a tailpipe that sits off-centre or low, visible cracks or splits in the rubber, and excessive exhaust movement when the engine is blipped. Any contact marks on the body, beam or heat shields also point to a sagging mount.

Can universal exhaust hangers be used on a 1998 Barina?

Yes, many universal rubber hangers will work if the hole spacing and thickness suit the Barina’s hanger pegs and brackets. However, vehicle-specific rubbers tend to fit better and maintain the factory exhaust height and angle, reducing the chance of knocks or premature wear.