Parts for your 1996 Daihatsu Gran move-Exhaust mount

1996 Daihatsu Gran Move Exhaust Mount

Yes, the 1996 Daihatsu Gran Move uses exhaust mounts. Technical sources including the Daihatsu Gran Move/Pyzar (G300-series) factory workshop manual (exhaust system section) and the Daihatsu Electronic Parts Catalogue specify rubber exhaust hangers/insulators and brackets to suspend the exhaust. Major aftermarket catalogues for this model also list replacement exhaust mounting rubbers, confirming they’re a fitted service item.

The exhaust mount on a 1996 Gran Move does a simple but vital job: it holds the exhaust system in place while isolating vibration. By suspending the front pipe, catalytic converter and muffler on rubber insulators, it stops exhaust weight and movement being transferred into the body and the manifold. That means fewer rattles, less stress on welds and flanges, and correct alignment so the system doesn’t knock on heat shields or the rear beam.

These rubber mounts live under the car and cop heat, road grime and the odd splash of oil, so they harden, crack or stretch with age. As part of routine servicing, it’s smart to inspect them every 10,000–15,000 km or whenever the exhaust is off the car. Look for perished rubber, elongated holes, separated bonding, or a sagging tailpipe. If one mount has failed, the rest usually aren’t far behind—replacing them as a set helps keep the system square and quiet.

Replacement is a straightforward, low-cost job. Let the exhaust cool completely, support it with a jack and stands, and spritz the old rubbers with silicone spray to make removal easier. Check the steel hangers and brackets for rust or bent tabs while you’re there, clean and tighten fasteners to the factory specification from the service data. Where available, use mounts that match the original shape and hardness. Polyurethane mounts can last longer but may transmit a touch more vibration.

Typical signs the mounts need attention include:

• Clunks or tapping over bumps from the muffler or pipe
• Visible droop or misalignment of the tailpipe
• Exhaust buzz at idle from contact with shields or crossmembers
• Fresh soot marks where the pipe has been touching the body

Keeping the Gran Move’s exhaust mounts fresh helps protect the manifold and flanges, keeps the cabin quiet, and saves the rest of the system from premature fatigue—easy preventative maintenance that pays off.

FAQs

How often should the exhaust mounts be replaced on a 1996 Daihatsu Gran Move?

There’s no fixed interval, but inspecting them every 10,000–15,000 km works well. In Aussie and Kiwi conditions, many last 5–10 years, though heat and oil contamination can shorten that. Replace at the first sign of cracking, elongation or sagging, and consider doing all mounts together to keep the system aligned.

What symptoms point to a failed exhaust mount on a Gran Move?

Listen for knocks over bumps, a buzz at idle, or a new rattle on cold start. A tailpipe that sits off-centre, touches the bumper, or leaves soot marks on nearby panels is another giveaway. If the exhaust moves excessively by hand, the rubbers are likely tired.

Can generic exhaust hangers be used, or should they be model-specific?

Quality universal hangers can work in a pinch, but the best result comes from mounts that match the Gran Move’s original shape and hardness. Incorrect geometry can leave the muffler crooked or too close to the body, causing noise and premature wear. If using universal parts, choose ones with equivalent dimensions and durometer.